MASTERVOLT MB20041223 40 Inch Digital Electric Smoker Instruction Manual

MASTERVOLT MB20041223 40 Inch Digital Electric Smoker

• Product Name: Body Kit, GSGXT
• Model Numbers: MB20041223, MB20043024

Body Disassembly

1. Have a second person hold the hopper in place while you remove 2 screws from the top next to the manifold inside the body to disconnect the hopper.
2. Lay the hopper down, remove the lid, and unscrew 16 screws from the cart while the grill is upright.
3. Lift the body off of the cart and set it on the ground upside down for further assembly.

Frequently Asked Questions (FAQ)
Q: Can I reassemble the grill body back onto the cart?
A: Yes, after disassembly, you can follow the reverse steps to reassemble the grill body onto the cart.

MB20041223, MB20043024

Body Kit, GSGXT

CAUTION

• Always remove plug from outlet before servicing your grill.
• Make sure your grill has fully cooled to avoid burns.
• Some components may have sharp edges. Use caution to avoid injury.

Note: Your grill may vary from images shown

1. Disconnect the power plug and remove the power cord from the leg.

2. Remove: charcoal from hopper, cooking grates, warming rack, all 3 manifold pieces, ash tray, grease tray, and any other accessories on the grill.

3. Remove the front shelf (4 screws).  Save for reuse.
   

4. Remove the side shelf and handle (4 screws). Save for reuse.

5. Remove the front hopper shroud.

   • Remove the hardware that connects
     the leg brace to the legs.

   • Remove the hopper ash door.

6. Remove 1 screw on the shutdown flap handle. Unscrew the shutdown slide handle.

7.  Remove 3 screws on the shutdown flap hopper shroud. Remove the shroud.

8. Remove the controller connections.

9. Remove the 4 thumb screws from the back of the controller. Remove the controller

10. Disconnect two black and white wire connections on the side of the controller .

11. Remove 6 screws from rear of controller and remove the back panel .

12. Disconnect 2 wire connections and feed the controller wire through the hopper pass through holes. Note, you will have to remove a zip tie from the inside of the hopper .

13. Remove the bottom (2 screws) next to the manifold inside of the body.

14. USE CAUTION, this step will disconnect the hopper from the body. Have a second party hold the hopper in place as your remove the hardware. Remove the top (2 screws) next to the manifold inside of the body. This will disconnect the hopper.
    Remove the hopper from the body.

15. Lay the hopper down.

16. Remove the lid.

17. Remove 16 screws from cart while grill is upright. Lift body off of cart and set on ground. 

Replace with new grill body – follow all steps in reverse order.
NOTE: If it is challenging to get the new grill body seated into the cart, it is recommended that you place the new body on the ground upside down and assemble the cart to the grill body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>