RFID SecureEntry-CR40 Reader with Access Control User Manual
- June 25, 2024
- RFID
Table of Contents
User Manual
RFID reader with access
control
SecureEntry-CR40
Specifications:
- Warranty: 1 year
- RFID Card Supported: 125 kHz
- Device Type: Access Control RFID Card Reader
- Interface: Wiegand 26
- Verification Type: RFID Card
- Access Control: Yes
- Voltage: 9~24V DC
- Ingress protection: IP66
- Reading Distance: > 3cm
- Operating current: 25 mA
- Operating temperature: -40°C~60°C
- Operating humidity: 10% to 95%
- Product dimensions: 105 x 20 mm
- Package dimensions: 103 x 48 x 19 mm
- Product weight: 180 g
- Product weight with packaging: 260 g
Set contents:
- RFID reader with access control
- Screws and mounting plugs
- Manual
Features:
- The RFID reader can be combined with an electric lock, thanks to which we will obtain a device that allows us to manage access to rooms and buildings.
- The device supports RFID cards with 125 kHz frequencies
- The access control system has a water-resistant housing with IP66 protection, so it can be installed outdoors.
- The reader is equipped with a Wiegand 26 interface, which allows it to be connected to a time recorder and transfer data.
Installation
- Drill 2 holes in the wall for screws (A, C) and one hole for wire (B)
- Drive the rubber pins into the holes (A, C)
- Attach the back cover to the wall with 2 screws
- Insert the wire through the cable hole (B)
- Attach the device to the back cover
Function Table
Reading the card| The LED will turn green and the buzzer will beep, meanwhile,
the reader will send a Wiegand signal.
---|---
External LED Control| When the input voltage for the LED is low, the LED will
turn green
External buzzer control| When the input voltage for the buzzer is low, the
buzzer will make a sound
Wiegand Data Output| The factory default setting is 26 bits.
Wiring Diagram
| Colour | Function | Comments |
|---|---|---|
| Red | Power | +DC (9-24V) |
| Black | GND | Ground |
| Green | D0 | Data 0 |
| White | D1 | Data 1 |
| Brown | LED | Green LED control |
| Yellow | Buzzer | Buzzer control |
(Note: The brown and yellow wires are optional connections.)
Data Signal
| Description | Reader Typical Time |
|---|---|
| Pulse Duration | 42 μS |
| Pulse Interval Time | 2 mS |
The table above shows the waveform of time, pulse width (pulse duration), and interval time (time between pulses) of Wiegand data sent from readers. (Example 1010)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>