tp-link 7106510203 Indoor Access Point Installation Guide

tp-link 7106510203 Indoor Access Point

Product Information

The product is an Indoor Access Point (AP) that allows for wireless connectivity in a network. It can be centrally configured and monitored using either the Omada Software Controller or Omada Hardware Controller. The AP can be installed either by ceiling mounting or wall mounting.

Network Topology

A typical network topology for the AP is shown below.

All APs can be centrally configured and monitored via Omada Software Controller or Omada Hardware Controller. You can get Omada Software Controller from our website https://www.tp-link.com.

Hardware Installation

• Option 1: Ceiling Mounting
  Follow the steps below to install the AP with the provided accessories:
  Note: The mounting bracket and the accessories (quantity and size) may vary by product.

1. Remove the ceiling tile.
2. Place the mounting bracket in the center of the ceiling tile. Mark positions for the screw holes and a position for the Ethernet cable hole. Drill 4 mm diameter holes for the screws and a 25 mm diameter hole for the Ethernet cable at the marked positions.
3. Secure the mounting bracket to the ceiling tile using pan-head screws, washers and wing nuts.
4. Feed the Ethernet cable through the hole and set the ceiling tile back into place.
5. Connect the Ethernet cable to the Ethernet port. Attach the AP to the mounting bracket by aligning the arrow mark on the AP with the arrow mark on the mounting bracket, then rotate the AP until it is locked into place.

• Option 2: Wall Mounting
  Follow the steps below to install the AP with the provided accessories:
  Note: The mounting bracket and the accessories (quantity and size) may vary by product.

1. If your Ethernet cable feeds through the wall, position the mounting bracket and feed the Ethernet cable. Mark positions for the screw holes and then drill 6 mm diameter holes at the marked positions.
2. Insert the plastic wall anchors into the 6 mm diameter holes.
3. Secure the mounting bracket to the wall by driving the self-tapping screws into the anchors. Make sure that the shoulders of the mounting bracket are on the outside.
4. Connect the Ethernet cable to the Ethernet port on the AP.
5. Attach the AP to the mounting bracket by aligning the arrow mark on the AP with the arrow mark on the mounting bracket, then rotate the AP until it is locked into place.

Power Supply

Power via PSE Device or Power Adapter
Some APs can be powered via the power adapter or the PSE device (such as a PoE switch) which complies with Power Source Class 2 (PS2) or Limited Power Source (LPS) of IEC 62368-1.
Note: Availability depends on the actual product. Please refer to the product specifications.

• Via PoE Switch
• Via Power Adapter

Power via PoE Adapter
Some APs can be powered via the PoE adapter.
Note: Availability depends on the actual product. Please refer to the product specifications.

Safety Information

• Safety Information
• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device.
• Do not use damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended.
• Do not use the device where wireless devices are not allowed
• Adapter shall be installed near the equipment and shall be easily accessible.

Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.

For technical support, the user guide and other information, please visit https://www.tp-link.com/support/, or simply scan the QR code.

References

• TP-Link Polska – Rozwiązania Wi-Fi dla domu i biznesu
• TP-Link Product Support - Wireless Networking Equipment Support
• CE | TP-Link

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>