LEZYNE 72062 Super Pro GPS Bike Computer User Guide
- June 13, 2024
- Lezyne
Table of Contents
LEZYNE 72062 Super Pro GPS Bike Computer
PRODUCT INFORMATION
USING THE HEART RATE SENSOR
- Slightly moisten the electrode area of the strap.
- Attach the Heart Rate Sensor to the strap buttons.
- Adjust the strap length and wrap it around the chest. Insert clasp to strap end. Make sure the chest strap is fastened on your body properly.
- Ensure the electrode area is pressed firmly against your skin, and position the sensor at the center of your chest.
GETTING STARTED
Lezyne Heart Rate Flow Sensor can be paired with Lezyne GPS and most fitness
apps. Compatible with Android & iOS smartphones. To get started with the
Lezyne Heart Rate Sensor, please pair it with a Lezyne GPS product, for more
instructions, see the user guide of your Lezyne product
CARING FOR YOUR HEART RATE SENSOR
Follow the care instructions to ensure reliable measurement and to maximize the life span of the heart rate sensor.
- Connector : Remove from the strap after every use and dry the device with a soft towel. Clean the device with a mild soap and water solution when needed.
- Strap : Rinse the strap under running water after every use and hang it to dry. Clean the strap gently with a mild soap and water solution when needed.
- Dry and store the strap and the device separately. Keep the heart rate sensor in a cool and dry place.
- Do not use moisturizing soaps, they can leave residue on the strap.
- Do not soak, iron, dry clean, or bleach the strap.
- Do not bend the electrode areas sharply.
- Do not store the heart rate sensor wet to prevent snap corrosion.
SPECIFICATIONS
- Adjustable length of strap: 610/880mm (Maximum900
- Length of sensor module: 270mm
- Weight : 47g(with battery)
- Water Resistance : 1m
- Battery : CR2032 (3 volts)
- System Compatibility : Bluetooth
- FCC ID : 2AD4S-LEZYNE-HR01
- IC ID: 20084-LEZYNEHR01
PAIR THE SENSOR WITH LEZYNE GPS
Lezyne GPS
- Main Menu
- Sensors
- Heart Rate
- Scan BTLE
- Heart Rate
HOW TO CHANGE THE BATTERY
NOTE : Remove the insulation plastic cover on the battery body before use.
- Use a coin to open battery cover 0 by turning counterclockwise.
- Replace CR2032 battery 2 and make sure the sealing ring 3 is in the groove to ensure water resistance.
- Press the cover back and turn the cover clockwise to CLOSE.
MORE INFORMATION
For more information on Lezvne products visit
www.lezvne.com
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to interference actions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/V technician for help.
CAUTION:
Avoid the user’s sanity to operate the equipment by the grantee of this device
could conditions. pies are ide ice may not cause interference, and to this
device must accept any interference received, including interference that may
cause undesired operation.
RF exposure warning
This equipment must be installed and operated by provided instructions with
antenna installation instructions and transmitter operating conditions for
satisfying Kr exposure compliance.
Canada, Industry Canada (IC) Notices
This device complies with Canada license-exempt Ros standard(S). Operation is
subject to the following two conditions:
- this device may not cause Interterence, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
This device has also been evaluated and shown compliant with the IC RF
Exposure limits under mobile exposure conditions. (antennas are greater than
20cm from a person’s body).
WARNING: KEEP OUT OF REACH OF CHILDREN
- BUTTON CELL BATTERIES ARE HAZARDOUS. NEW AND USED BATTERIES SHOULD BE KEPT AWAY FROM CHILDREN.
- LITHIUM COIN BATTERIES CAN CAUSE SEVERE OR FATAL INJURIES IN 2 HOURS OR LESS IF IT IS SWALLOWED OR PLACED INSIDE ANY PART OF THE BODY.
- SEEK MEDICAL ATTENTION IMMEDIATELY IF IT IS SUSPECTED THE BATTERY HAS BEEN SWALLOWED OR PLACED INSIDE ANY PART OF THE BODY.
Lezyne USA, 645 Tank Farm Rd., Unit F, San Luis Obispo, California 93401
72062-Y10-HEART RATE-QUICK START-R1-E1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>