Global Cache FLC-BL Flex Link Blaster Cable User Guide
- June 23, 2024
- Global Cache
Table of Contents
Quick Start Guide
Flex Link Cable
Flex Link Blaster Cable (FLC-BL)
Getting Started
Once the Flex is connected to the network (see Flex Quick Starts), plug the Flex Link Blaster cable (FLC-BL) into the Flex Link Port.
To configure the FLC-BL, right-click on the unit entry in iHelp and select Configure , or enter the Flex unit’s IP address into a web browser to access the Flex Configuration page.
- Micro-B USB to Power Connector
- Flex Link Port
To access the settings, select the Flex Link Cable tab. Then select Infrared from the Change Flex Link cable field, then select Single Blaster (FLC-BL). If using a Flex Link Tri-Port cable (FLC-T3), select 2 Emitter, 1 Blaster (FLC-2E1B) and plug the FLC-BL into IR port 3 of the FLC-T3 cable.
Select Save Changes to apply the new settings.
Please note the FLC-BL is designed to be used with Global Caché Flex products only. It transmits IR signals across a room up to 35 feet. The IR modulation frequency 20 to 500 KHz.
For detailed info on configuring and using the Flex and Flex Link Cables, consult the User Guide: Flex and Flex Link Cables at www.globalcache.com/docs.
Scan for APIs, user guides, docs, and utilities.
Global Caché, Inc.
160 East California Street
PO Box 1659
Jacksonville, Oregon 97530
Phone 541-899-4800
www.globalcache.com
support@globalcache.com
Copyright ©2024 Global Caché, Inc. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>