Bobtot ET510 Portable Speaker User Guide

June 21, 2024
Bobtot

Bobtot ET510 Portable Speaker User Guide

Bobtot ET510 Portable Speaker - product image

What’s in the Box

Check to make sure you have everything below.

Bobtot ET510 Portable Speaker - What's in the Box

A: 1 ET510 Portable Party Speaker
B: 1
Wire Microphone
C: 1 DC adapter
D: 1
Type-C USB Charging Cable
E: 1 3.5mm AUX Audio Cable
F: 1
Quick Start Guide

Device Overview

Bobtot ET510 Portable Speaker - Device Overview

01——–Power On/Off
02——–Bass Boost
03——–Play/Pause
04——–Volume Down /Previous Button
05——–Volume Up /Next Button
06——–Multi-function Button
07——–Party Light Button
08——–DC Input
09——–USB Input
10——–Type-C Charge out
11——–Mic Input
12——–AUX Input

Charging Your Device

Bobtot ET510 Portable Speaker - Charging Your Device

Turn On/Off

Bobtot ET510 Portable Speaker - Turn On off

BT Connection/Disconnection

Bobtot ET510 Portable Speaker - BT Connection or
Disconnection

TWS Sync Mode

Bobtot ET510 Portable Speaker - TWS Sync Mode

  1. Turn on the two speakers and disconnect the BT connection.
  2. Double click both “M” buttons for over 2 seconds. The blue lights of the main speakers is flash alternately. After connecting, the blue lights will stay blue.
  3. Search for BT device named “Bobtot ET510” and connected.

NOTE: Double-click the “M” button exit TWS Mode. In TWS mode, turn off one of the speaker, both of them are off.

Multi-function

Bobtot ET510 Portable Speaker - Multi-function

AUX/USB/BT
Plug AUX or USB flash drive into the speaker, it will auto matically play. When using one of the connection ways, please make sure the other source is disconnected.

Microphone Function
After plug the microphone into the speaker,
Short Press “M”: adjust microphone volume +/-.
Long Press “Bass”: choose the microphone model like Karaoke/Vocal/KTV.
Double Click “Bass”: Microphone priority

Button Instruction

Bobtot ET510 Portable Speaker - Button Instruction

Charging Out

Bobtot ET510 Portable Speaker - Charging Out

Resetting Your Device

If your speaker is not operating properly, you may reset it. To do so, use a small object such as a paper clip – to press the button inside the AUX jack. Press and hold the button for approximately 2 seconds until the speaker powers off, and then power it on again as usual.

Specification

-Peak Power: 70W
-BT/AUX/USB/MIC Function
-Built-in rechargeable battery
-Battery: 11.1V 4400mA
-Playtime: Up to 24 hours
-Charge Out:DC5V 2A
-Charging Input: DC 20V/3.2A
-Microphone Supported
-BT with up to 33ft(10m) range
-Frequency Response: 20Hz-20KHz
-IPX5 Water-resistant, sprayproof
-TWS Sync Mode (True Wireless Stereo)

FCC Warming

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Need help?

Customer Care Guide At our company, we strive to provide exceptional customer care to every one of our clients. We believe that building strong relationships with our customers is essential to the success of our business. To help us achieve this goal, we have put together the following customer care guide.

Time
We understand that our customers’ time is valuable, so we will respond to any inquiries within 24 hours.

Feedback
We know that our customers are the heart of our business so we value your feedback. We encourage you to share your thoughts and ideas with us.

Solutions
If our customers encounter any issues, we will try our best to find a quick and efficient solution that meets your needs.

Here at Bobtot, we take customer care very seriously. Our customers are our first priority, and we are committed to providing the highest quality service.

If you have any questions or concerns, please don’t hesitate to reach out to us.
We will be happy to assist you:
Call or Message: +1 888 572 1718
Email: service@bobtot.net

bobtot.net
©2024 BOBTOT // Features and specifications are subject to change and or improvement without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals