GRACO 9AU100 Motion and Vibration Baby Bassinet Instruction Manual
- June 13, 2024
- Graco
Table of Contents
GRACO 9AU100 Motion and Vibration Baby Bassinet
Specifications :
- Motion Speed Options: 3
- Vibration Options: 2
- Music/Sounds Options: 5
- White Noise Options: 5
- Cry DetectionTM Technology with 5 preset sequences
Product Usage Instructions
Motion:
Press the motion selection button to cycle through 3 motion speed options
and off. Hold the button to turn off completely.
Vibration:
Use the vibration selection button to cycle through 2 vibration options and
off. Press and hold to turn off.
Music and Sounds:
Press the Music and Sounds selection button to cycle through 5 music/sounds
options. Hold the button to turn off.
White Noise:
Press the White Noise selection button to cycle through 5 sounds. Press and
hold the button to turn off.
Tactile Sound:
If Music and Sounds or White Noise are on, pressing the vibration selection
button will add tactile sound that follows the sound being played.
Sound Volume:
Use the Volume Up button to increase volume and the Volume Down button to
decrease volume. Press and hold the Volume Down button to turn off sound.
Cry DetectionTM Technology:
To activate Cry DetectionTM Mode, press the power button and choose Cry
DetectionTM Mode. The technology detects baby crying and adjusts settings to
soothe the baby.
Bassinet Troubleshooting:
Bassinet Won’t Operate:
- Ensure you are using the original wall plug.
- If the bassinet is not moving, check for obstacles blocking its path or if the baby exceeds 20 lb (9 kg).
- If the baby is too heavy or active, discontinue use.
Bassinet Isn’t Moving Smoothly:
- Adjust the speed setting if it is too low.
- Check for objects obstructing the bassinet’s movement.
- If the baby is too heavy or active, discontinue use.
Bassinet Doesn’t Detect Baby Crying:
- Ensure the Cry Detection setting is activated. Check if the Cry
The detection sensor is functioning properly.
Read all instructions BEFORE assembly and USE of the product. KEEP INSTRUCTIONS FOR FUTURE USE.
WARNING
Failure to follow these warnings and instructions could result in serious injury or death.
- • PLEASE SAVE THE OWNER’S MANUAL FOR FUTURE USE.
• DO NOT use the product if it is damaged or broken.
• THIS PRODUCT REQUIRES ADULT ASSEMBLY. Follow assembly instructions carefully. If you experience any difficulties, please contact the Customer Service Department 1-800-345-4109.
SUFFOCATION HAZARD
Infants have suffocated:
- In gaps between a wrong-sized mattress or extra padding and side of the bassinet, and
- On soft bedding, pillows and extra bedding.
- Use ONLY the mattress pad provided by Graco.
- NEVER add a pillow, comforter or another mattress for padding.
- ALWAYS use mattress pad provided by Graco.
- The product can roll over on soft surfaces and suffocate child. Never place product on beds, sofas, cushions, or other soft surfaces.
- To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise advised by your physician.
- ALWAYS place child in the center of the bassinet.
- FALL HAZARD: Infants have suffered head injuries falling from bassinets and swings.
- To help prevent falls, STOP using this product when the infant begins to push up on hands and knees, weighs over 20 lb (9 kg)(approximately 5 months of age), or child’s head and feet simultaneously touch head and foot ends of bassinet mesh sides, whichever comes first.
- The product must be fully assembled and installed, including 4 legs, 4 screws, 2 top rails, 2 side mounts, and a mattress pad, before using. Always follow the instructions in the owner’s manual to set up the product.
- ALWAYS provide the supervision necessary for the continued safety of your child. When used for swinging, never leave child unattended.
- NEVER lift or move a product with infant in it.
- NEVER use product on slick surfaces.
STRANGULATION HAZARD:
- Strings can cause strangulation!Do not place items with a string around a child’s neck such as hood strings or pacifier cords. Do not suspend strings over a bassinet or cradle or attach strings to toys.
- DO NOT place product near water and moisture. Do not use the product near possible wet areas, such as a bathtub, shower, wash basin, sink, laundry tub, swimming pool, wet basement, etc.
- DO NOT use the AC adapter if it has been exposed toliquids, has been dropped,or is damaged.
- Protect the power cord. Place it so it is not walked on or pinched by furniture or other items.
- DO NOT use with an extension cord.
- Use only 5V power cord provided.
- If a sheet is used with the mattress pad, use only the one provided by Graco that is specifically designed to fit the dimensions of the mattress pad.
- To help prevent heat build-up inside the bassinet and to avoid overheating your child, NEVER use an outdoor canopy.
- ALWAYS keep objects out of child’s reach.
- DO NOT use product as a car bed.
- NEVER allow child under the product.
FCC
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. CAN ICES-3 (B) /NMB-3 (B).
Parts List
This model may not include some features shown below. Check that you have all the parts for this model BEFORE assembling your product. If any parts are missing, call Customer Service.
Tools required (not included): Phillips Screwdriver
ALL MODELS
Red bag contains hardware, do not discard
- A. Base Leg (with plugs)• Pata de la base (con tapones)
- B. Bassinet with Mattress Padand 2 Top Rails • Moisés conalmohadilla de colchón y dosbarandas superiores
- C. Base Leg • Pata de la base
To Assemble Base
Base Feet
Parts Required
Tools required
Phillips Screwdriver
-
Place product (B) with the bassinet down as shown
-
Choose the base leg with (A) sticker. Attachleg (A) to the mount on the bassinet with the (A) plug sticker, opposite the control panel.
Fasten leg with screw -
Plug wire from leg (A) into plug opening in base.
Parts Required -
Attach the remaining 3 base legs (C) to the remaining mounts, and fasten each with a screw. CHECK legs are assembled by pulling out on them.
-
Stand bassinet up
To Assemble Bassinet
Parts Required
- Remove mattress pad from bassinet
- Pull up the bassinet fabric and open fabric flaps covering the 2openings in the ends of bassinet.
- Insert plastic side mounts (D) with snap fingers facing inward, into the top fabric openings of bassinet.
Route the snap fingers out the bottom fabric opening, and snap into the base.
CHECK side mounts are attached by pulling on them.
NOTE : side mounts can be used in either end of the bassinet.
www.gracobaby.com
©2024 Graco NWL0001529527D