Solo 462 7 Litre Portable Sprayer Instruction Manual
- June 13, 2024
- Solo
Table of Contents
Operator’s Manual & Spare Parts List
Model 462
WARNING: READ INSTRUCTIONS CAREFULLY BEFORE USING THIS UNIT.
462 7 Litre Portable Sprayer
CAUTION:
- Do not leave a pressurized sprayer in direct sunlight or near heat source. Heat can cause build up of excessive pressure.
- Do not store or leave solution in tank after use.
- Always wear goggles, long sleeve shirt, long pants and full foot protection when spraying.
- Never use any tool to remove pump while sprayer is pressurized. Never stand with face or body over top of tank when pumping or loosening pump, to prevent ejected pump assembly and/or solution from striking and injuring you. Never pressurize sprayer by any means other than the original pump.
- Do not attempt to modify or repair this product except with original manufacturer’s parts.
- NEVER SPRAY FLAMMABLE MATERIALS. ALWAYS READ CHEMICAL LABEL BEFORE FILLING SPRAYER AS SOME CHEMICALS MAY BE HAZARDOUS WHEN USED WITH THIS SPRAYER.
- PRE-USE CHECK: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are found, replace hose before using. Replace with original manufacturer’s parts only. Remove pump (see filling, pressurizing and spraying instructions). Inspect interior and exterior of tank for signs of deterioration (i.e. rust, bubbling and/or pitting) of body and bottom. Any sign of deterioration indicates possible tank weakening and could result in explosive bursting under pressure. If any of these signs are found, discard tank immediately and replace. Do not attempt to patch leaks, etc., as this could result in serious injury. Follow filling, pressurizing and spraying instructions EXCEPT: USE WATER ONLY. Pump plunger only 8-10 strokes and inspect for leaks.
Direct shut-off valve away from you and open to make sure discharge is not clogged. If unit passes this test, release pressure (see pressure releasing instructions), empty tank, and proceed with filling, pressurizing and spraying instructions.
Customer Service Commitment From Solo’s Service Department
In the event the sprayer you have purchased has missing or damaged parts,
please call 1-800-765-6462, 9:00 AM –
5:00 PM EST.
In order to assist your representative, please have the following information
available: sprayer model number, description and part number. A parts list is
included in your operator’s manual.
Solo is committed to your satisfaction and continuing its efforts to earn your
future business.
Visit us on the web at www.solousa.com
Parts ordering available on-line, or call Solo’s order desk at
757-245-5531
FILLING, PRESSURIZING AND SPRAYING INSTRUCTIONS: Engage handle in lock
position: By pushing handle down to compress spring and rotate handle 1/4 turn
clockwise, then allow handle to raise into the lock position. To remove pump:
WIth handle in locked position, turn pump counter-clockwise until pump can be
removed from tank. Prepare spray solution following directions on chemical
label. Strain solution and fill tank to indicated usable capacity, leaving
remaining space for compressed air.
To close after filling:
NOTE: Check pump barrel to be sure no dirt or grass is stuck to barrel.
Place pump into opening and rotate clockwise until tightly locked and sealed
in tank opening. To pressurize sprayer disengage handle from locked position,
push down, turning 1/4 turn counterclockwise to release handle and then pump
plunger up and down until resistance is achieved.
To engage handle in lock position push handle down to compress spring and
rotate handle 1/4 turn clockwise, then allow handle to raise into the lock
position.
WARNING: THIS SPRAYER IS NOW UNDER PRESSURE AND COULD BE DANGEROUS IF NOT
HANDLED PROPERLY.
Always wear goggles, gloves, long sleeve shirt, long pants and full foot
protection when spraying.
If unit is supplied with adjustable nozzle, point nozzle away from you,
squeeze shut-off valve to open and adjust nozzle to desired spray pattern by
rotating nozzle cap (not complete nozzle) clockwise for fine spray to solid
stream (maximum 2 turns).
WARNING:
TURNING NOZZLE CAP TOO FAR WILL RESULT IN CAP FLYING OFF ALLOWING SPRAY
MATERIAL TO SPRAY BACK ON YOU.
If unit is supplied with fan nozzle, nozzle cap can be rotated by loosening
nozzle retainer, rotate nozzle, and re-tighten retainer. Pump unit as required
to maintain pressure.
CLEANING INSTRUCTIONS: Rinse tank thoroughly with mineral spirits only, empty,
refill with 1/2 pint of mineral spirits only. Follow filling, pressurizing and
spraying instructions, except to pump unit only 8-10 strokes. Open shut-off
and allow mineral spirits to run through shut-off valve and wand. Release
pressure (follow pressure release instructions), remove pump and empty
sprayer. Use soap and water solution to remove mineral spirits residue.
SPRAYER CARE, STORAGE AND MAINTENANCE: Sprayer tank should be hung upside
down, with pump removed, in a warm dry location. Periodically remove nozzle
and extension tube from shut-off. With shut-off valve discharge hole pointing
upward, place 6-8 drops of light oil into discharge hole. Pump should be
periodically oiled by dropping 10-12 drops of light oil down pump rod, through
opening in cover. If nozzle clogs remove complete nozzle assembly, then
disassemble and clean openings of any obstructions.
Limited Warranty
If the sprayer fails to perform properly under normal household use for a
period of five (5) years from date of purchase due to a defect in material
and/or workmanship, Solo will repair or replace at its discretion.
This limited five (5) year warranty does not apply to damage resulting from
accident, neglect, misuse, commercial use, alteration, operation not in
accordance with instructions or repairs made or attempted by unauthorized
persons. The manufacturer’s liability
hereunder is limited solely to the repair or replacement of the defective
product or part, and incidental or consequential damages which may result from
any defect in material or workmanship or from the breach of any express or
implied warranty.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitation of how long an implied warranty lasts, so
the above limitations may not apply to you. This warranty gives you specific
legal rights, and you may have other
rights which may very from state to state.
If you have questions regarding sprayer operations, please call Solo Customer
Service at: 800-296-7656.
For repair or replacement, return sprayer with original dated purchase receipt
to:
Solo Incorporated
201 Enterprise Drive, Newport News, Virginia 23603
SPARE PARTS LIST
KEY NO. | PART NO. |
---|---|
2 | 33000084S |
4 | 33000233-PS |
4 | 33000244-PS |
5 | 33000237S |
6 | 33000251S |
DESCRIPTION
Shut-off valve 12″ Poly extension Extension Nozzle assembly Repair parts kit
This kit contains parts most frequently required and will service your sprayer
in ordinary use for approximately 2 years
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>