EMERSON Go Tracker 1.9 Real-Time Temperature and Location Trackers User Manual

: June 3, 2024
: Emerson

Table of Contents

EMERSON Go Tracker 1.9 Real-Time Temperature and Location Trackers
Revision History
CE Regulations
FCC Regulations
CONTACT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

EMERSON Go Tracker 1.9 Real-Time Temperature and Location Trackers

Revision History

Revision	Date	Description
1.00	04/05/2022	Initial Release

CE Regulations

Caution

Risk of explosion if battery replaced aced by an incorrect type.
Dispose of used batteries according to the instructions.
The technical documentation relevant to the above equipment will be held at Emerson Digital Cold Chain, Inc
Please make sure the temperature for the device will be from -20˚C to 60 ˚C.
The manufacturer specified the maximum ambient temperature for use in the charging mode of 40 ˚C and for use in the non-charge mode of 45 ˚C.
The minimum distance between the user and/or any bystander and the radiating structure of the transmitter is 20cm.
This radio equipment operates with the following frequency bands and maximum radio-frequency power:
Features| Description
---|---

Frequency Band

| CAT M1 LTE-FDD: B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B26/B27/B28/B66/B85 Cat NB2 LTE-FDD: B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B28/B66/B71/B85

EGPRS: 850/900/1800/1900MHz

Max. TX power

| EGPRS 900 : 33.5 dbm

EGPRS 1800 : 31 dbm

CAT M1/NB2 LTE B1/3/8/20/28: 22 dbm

FCC Regulations

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.

RF Exposure Information
This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.

ISED Notice
This device complies with the Innovation, Science and Economic Development Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

This device may not cause interference, and
This device must accept any interference, including interference that may cause undesired operation of the device.

This device complies with the Canadian ICES-003 Class B specifications. CAN ICES-003(B)/ NMB-003(B)

ISED RF Exposure Statement
This device complies with ISED RSS-102 RF exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the IC RSS-102 RF exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.