STOCCO 304 Glass Rinser Owner’s Manual
- June 1, 2024
- STOCCO
Table of Contents
304 Glass Rinser
Read all instructions steps before installation.
Turn off hot and cold water supplies at angle stops before installing glass
rinser
A. For sinks with level ledges/Granite, Don’ t need the plastic spacer
B. For sinks with the raised ledges, Put the plastic spacer on the sink hole
with foam washer side downward.
A. Put the base on the sink hole.
B. Put the base on the plastic spacer.
Insert the shank into the hole.
Screw the the black gasket and the nut onto the shank, and tighten.
Thread the 1/2″ end of provided supply line to mounting shank with wrench.
Choose cold or hot water for your glass rinser. Unthread existing faucet
supply line from angle stop on the chosen side. Thread provided tee onto angle
stop .
Thread both the faucet supply line and the 3/8” end of provided supply line to
tee. When supply line is installed, check alignment and retighten mounting
nut.
Put the silicon nozzle into the actuator arms.
Screw the actuator arms with the silicon nozzle onto the shank clockwise
Turn on both water supplies at angle stops and check for leaks at all
connections.
Finish and enjoy your easy life.
Note
Please read the following instructions carefully before installation.
Tip: This glass rinser will not sanitize or clean your glass or cups for
fully and this just do some physical cleaning of visible dirt.
Please pay more attention to the cleaning of this product. Although its finish
is extremely durable, it can be damaged by harsh abrasives or polish. To
clean, simply screw the actuator arm out , then wipe gently with a damp cloth
and blot dry with a soft towel.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>