Shark UV540 Series Navigator Lift-Away User Manual
- June 9, 2024
- Shark
Table of Contents
Shark UV540 Series Navigator Lift-Away User Manual
QUICK START GUIDE
UV540 Series
[ Please make sure to read the enclosed Information Booklet prior to using your unit. ]
ASSEMBLY
Simple steps to get you cleaning with your new Shark® Navigator® Lift-Away® Professional Vacuum.
CARPET AND BARE FLOOR CLEANING:
1. Attach floor nozzle (a) into the bottom of the canister (b).
2. Insert extension wand (c) into the back of the canister, slide on the
accessory holder (d) and place the on-board tools (e).
3. Insert handle (f) into the top of the extension wand and connect the hose
(g) to the back of the canister.
PORTABLE LIFT-AWAY®
1. Press handle release button to detach handle (or handle with extension
wand).
2. Press red nozzle release button (h), place foot on nozzle and pull the
canister up.
3. Attach desired tools to clean.
BRUSH ROLL ON/OFF:
1. Press the ON/OFF switch at the top of the canister to the ‘I’ position to
vacuum bare floors or to use with tools (straight suction only) or in Lift-
Away® mode or to the ‘II’ position to engage the motorized floor brush (for
vacuuming carpets and rugs).
2. Press the floor nozzle down with your foot and tilt the handle back
towards you to engage the brushroll.
USE AND CARE
IMPORTANT : Loss of Suction may occur if foam filters are not cleaned every 3 months. Rinse and allow to air dry completely. Also, tap loose dirt off filter between washes as needed. Foam filters may appear dirty after use – this is normal. Please refer to the maintenance section of the manual for instructions on cleaning the filters.
SUCTION CONTROL
The suction can be adjusted to make the vacuum easier to push and pull on
certain types of carpets as needed.
Adjust the amount of suction by rotating the suction release collar on the
handle counterclockwise to reduce the suction or clockwise for maximum
suction.
INDICATOR LIGHT
The motorized brush indicator light will illuminate Green when motorized floor brush is on. If there is a blockage or jam, the light will turn Red (see page 9 of the instruction manual).
EMPTYING THE DUST CUP
1. Pull up the latches on the sides of the dust cup to release.
2. Hold the dust cup over a trash receptacle and press the bottom door
release button.
3. If needed, turn the dust cup upside down over the trash and press the top
door release button.
CLEANING FILTERS
1. With the dust cup removed, pull the 2 filters out from the top of the
motor base.
2. Rinse the filters thoroughly in lukewarm water until the water runs clear.
3. Squeeze out excess water and let air-dry for at least 24 hours before
inserting back into the vacuum.
TOLL FREE: 1-800-798-7398
sharkclean.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>