logitech Lightspeed Wireless Installation Guide
- June 7, 2024
- Logitech
Table of Contents
- logitech Lightspeed Wireless Installation Guide
- LIGHTSPEED Wireless Gaming Mouse Souris gaming sans fil LIGHTSPEED
- SETUP INSTRUCTIONS
- Tips:
- 6 FULLY PROGRAMMABLE BUTTONS
- LED INDICATOR
- G HUB SOFTWARE
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
logitech Lightspeed Wireless Installation Guide
LIGHTSPEED Wireless Gaming Mouse Souris gaming sans fil LIGHTSPEED
SETUP INSTRUCTIONS
-
Remove the battery cover by pressing the top of the cover and pulling it downwards
-
Remove the receiver
-
Insert the battery
-
Close the battery cover
-
Make sure the mouse is turned on via the switch on the bottom of the mouse
-
Recommended: Insert receiver into the receiver extension cable. Insert extension cable into your USB port. Alternatively,
insert receiver directly into your USB port
-
Download the G HUB software
logitechG.com/GHUB
logitechG.com/support
Tips:
To make your mouse lighter, a lithium AA battery (not included) can be used.
––
Keep the mouse and receiver 2 m+ away from wireless routers or other 2.4GHz
wireless devices to minimize environmental noise. ––
G304 / G305 has a wireless range of up to 10 meters. To ensure optimal
performance in noisy wireless environments, it is recommended to keep the
receiver within 20 cm of the mouse.
6 FULLY PROGRAMMABLE BUTTONS
-
Left (Button 1)
-
Right (Button 2)
-
Wheel click (Button 3)
-
Forward (Button 4)
-
Back (Button 5)
-
DPI cycle (Button 6)
-
On/Off switch (bottom of mouse, not programmable)
LED INDICATOR
Battery life
Flashing red: battery <15%
DPI
Yellow: step 1 – 400 DPI
White: step 2 – 800 DPI (default)
Orange: step 3 – 1600 DPI
Magenta: step 4 – 3200 DPI
Blue: step 5 – 6400 DPI (Step 5 can be activated via software only)
Mode
Cyan: performance mode (default)
Green: endurance mode (can be activated via software only).
Tips:
Activating endurance mode will degrade tracking performance but improve
battery life.
G HUB SOFTWARE
You can customize the onboard profile settings using the G HUB. These settings include button programming, report rate, performance/endurance modes and tracking behavior. G304 / G305 allows up to 5 DPI settings.
By default, G304 / G305 has the following settings:
––DPI: 400/800/1600/3200
––Report rate: 1ms
––Performance mode
©2020 Logitech. Logitech, Logitech G, Logi and their respective logos are trademarks or registered trademarks of Logitech Europe S.A. and/or its affiliates in the U.S. and other countries. All other trademarks are the property of their respective owners. Logitech assumes no responsibility for any errors that may appear in this manual. Information contained herein is subject to change without notice
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>