audio-technica Subminature Cardioid Condenser Microphones for Wireless System User Manual

audio-technica Subminature Cardioid Condenser Microphones for Wireless

System User Manual

Thank you for purchasing this product. Before using the product, read through the user manual to ensure that you will use the product correctly.
Please keep this manual for future reference.

■ Features

• Maximum intelligibility and clean, accurate reproduction for lecturers, stage and television talent, and worship leaders
• Low-profile design (a mere 5 mm in diameter) is ideal for applications requiring minimum visibility
• Cardioid polar pattern improving isolation of desired sound source
• Includes an extensive array of accessories
• AT898cW equipped with cW-style locking and equipped with AT898cH cH-style screw-down 4-pin termination for Audio-Technica wireless systems

■ Notes on use

AT898cW and AT898cH are designed to be worn as a lavalier or hidden in loose clothing. For use as a lavalier, attach the microphone about six inches below the chin. Anticipate
movements that may cause the microphone to rub against or be covered by clothing, and position the microphone to avoid it. The wireless versions do not contain power module and included single and double mic holders are interchangeable with all the bases. To change the holders, simply remove original holder and snap in the desired one. When using the microphone in extremely close situations, slip the included openpore foam windscreen over the mic to reduce wind noise or “popping.”
Less power module and includes clothing clips, mic holders and windscreens. 1.4 m cable terminated with locking 4-pin connector. The connector is also compatible with Audio-Technica
cW and cH type body-pack transmitters. Avoid leaving the microphone in the open sun or in areas where temperatures exceed 43°C for extended periods. Extremely high humidity should also be avoided.

■ Safety precaution

Although this product was designed to be used safely, failing to use it correctly may result in
an accident. To ensure safety, observe all warnings and cautions while using the product

■Cautions for the product

• Do not subject the product to strong impact to avoid malfunction.
• Do not disassemble, modify or attempt to repair the product.
• Do not handle the product with wet hands to avoid electric shock or injury.
• Do not store the product under direct sunlight, near heating devices or in a hot, humid or  dusty place.

■ Specifications

2.6 mm diameter, 2-conductor shielded cable
(termination dependent)
  Included accessories|   AT8439 cable clip; clothing clip base; viper clip base;
magnet clip base and plate with lanyard;
three single mic holders; two double mic holders;
two windscreens; protective carrying case
---|---

• 1 Pascal = 10 dynes/cm2 = 10 microbars = 94 dB SPL
• Typical, A-weighted, using Audio Precision System One.
  For product improvement, the product is sublect to modification without notice

■Polar pattern

■Frequency response

Connection procedure

■Cable Terminations

Audio-Technica Corporation
2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan ©2017 Audio-Technica Corporation Global Support Contact: www.at-globalsupport.com

Read More About This Manual & Download PDF:

References

• Global Support｜Audio-Technica Corporation オーディオテクニカ

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>