TOMADO TDF5001B Cold Zone Fryer Instruction Manual
- June 3, 2024
- TOMADO
Table of Contents
TOMADO TDF5001B Cold Zone Fryer Instruction Manual
SAFETY INSTRUCTIONS
-
Carefully read the entire instruction manual prior to using the appliance and store it carefully for future reference.
-
Only use this appliance for the purposes described in the instruction manual.
-
Caution! Avoid contact with hot surfaces when the appliance is switched on.
-
Only connect the appliance to alternate current, to an earthed wall socket, with a mains voltage that corresponds with the information provided on the information plate of the appliance.
-
Never bend the power cord sharply or allow it to run across hot parts.
-
Fully unwind the cord to prevent it from overheating.
-
Never place the appliance near appliances that give off heat, such as ovens, gas cookers, hotplates, etc. Keep the appliance away from walls or other objects that may catch fire, such as curtains, towels (cotton or paper, etc.).
-
Always make sure the appliance is placed on an even, flat surface and is only used indoors.
-
Do not switch on the appliance with an empty reservoir.
-
Do not leave the appliance unsupervised if the appliance is operational.
-
Do not use a time switch or remote control to switch on the appliance, this is very unsafe.
-
Remove the cover from the fryer during use.
-
If you want to move the appliance, make sure it is switched off and has fully cooled down. Use both hands when moving the appliance.
-
If the frying fat catches fire due to overheating, never try to extinguish it with water! First remove the plug from the socket and extinguish the fire by placing the cover back on the reservoir and laying a wet cloth or extinguishing blanket over the appliance.
-
Do not use the appliance if the plug, cord or appliance are damaged, or if the appliance no longer functions properly or if it is damaged in any other way. If this is the case, consult the retailer or our maintenance service. Never replace the plug or cord yourself. Repairs to electrical appliances should only be performed by skilled persons.
-
Incorrect repairs could cause considerable hazards for the user. Never use the appliance with parts that are not recommended or supplied by the manufacturer.
-
Do not pull the cord and/or appliance to remove the plug from the wall socket. Never touch the appliance with wet or damp hands.
-
Keep the appliance out of reach of children. Children do not see the dangers associated with handling electrical appliances. Therefore, never allow children to operate electrical appliances without supervision. Keep the appliance and cord out of reach of children younger than 8 years of age.
-
The appliance may be used by children of eight years and older and by persons with limited physical, sensory or mental capacities or limited experience or knowledge, provided they use
the appliance under supervision or have been instructed about its safe use and understand the hazards involved. -
Children must not play with the appliance.
-
The appliance may not be cleaned or maintained by children, unless this is done under supervision.
-
If the appliance is not being used, or is being cleaned, fully switch off the appliance and remove the plug from the socket.
-
Make sure there is no moisture in the cover or reservoir before filling the fryer with liquid frying fat.
-
Never pour water, ice or other liquid in hot frying fat, this is very dangerous!
-
Never mix fat/oil. This could result in dangerous situations, such as an overflowing fryer.
-
If the appliance does not function after switching it on, it is possible that the fuse or circuit breaker in the electricity distribution box have been activated. The load on the group can be too high or an earth leakage could have occurred.
-
In case of a breakdown, never make repairs yourself; a tripped safety device in the appliance could indicate a defect that cannot be remedied by removing or replacing this safety device. Only original parts should be used.
-
Never submerge the element, cord or plug in water.
-
This appliance is intended for household and similar use, such as:
- in staff kitchens, in shops, offices and other work environments.
- by guests of hotels, motels and other residential environments.
- in Bed & Breakfast type environments
- farms
-
This appliance is only suitable for household use. If the appliance is not used as intended, no compensation can be claimed in case of defects or accidents and the warranty will be invalidated.
PRODUCT DESCRIPTION
-
Reservoir
-
Large frying basket with handle
-
Small frying basket with handle
-
Heating element
-
Cover
-
Exterior
-
Handle – outside
-
Indicator led – red
-
Thermostat led – green
-
Thermostat knob
-
Reset button
-
Cord storage compartment
PRIOR TO FIRST USE
Before using the appliance for the first time, proceed as follows: carefully
unpack the fryer and remove all packaging material. Keep the packaging
(plastic bags and cardboard) out of reach of children. After unpacking the
appliance, carefully check it for external damage that may have occurred
during transport. Place the fryer on a flat, heat-resistant surface. Remove
the cover and the frying basket. Now lift the element straight out of the
guides and remove the reservoir.
Clean the cover, frying basket and reservoir with warm water and a mild
washing-up liquid. Dry these components thoroughly. Make sure there is no more
liquid on the cover, frying basket or reservoir. Only clean the exterior with
a damp cloth and dry thoroughly. Re-assemble the fryer.
Fill the reservoir with liquid frying fat, between the minimum and maximum
level, 3 litres. The frying fat should not be below or above the maximum
level. In the reservoir there are two horizontal stripes that indicate the
minimum and maximum level.
Caution: it is only permitted to use the cold zone fryer with liquid
frying fat. Do not use hard frying fat, butter, margarine or olive oil.
The frying basket has been provided with a handle that is easy to store.
You can click in the handle and fold it inwards, so that the fryer can be
stored in a properly closed condition. Only fold in the handle once the frying
fat has fully cooled down and do not forget to fold it out again when using it
the next time, before heating up!
For the best result you should never use a cover when deep-frying with a cold
zone fryer.
DEEP-FRYING
Check that the voltage corresponds with what is stated on the information
plate. Check that the handle is properly folded out and switch on the fryer by
inserting the plug in the socket. The red indicator led starts to light up,
indicating that the fryer is connected to the power mains. Turn the thermostat
knob clockwise to the required temperature. The green thermostat led starts to
light up. The heating element is activated.
Caution: always remove the plastic handle of the frying basket from the
frying fat before heating up the fryer.
Otherwise the plastic will melt.
Once the required temperature has been reached, the green indicator led
switches off. When the temperature drops, both the thermostat and green
indicator led switch on again. The fryer is ready for deep frying.
Fill the frying basket (no more than two thirds) with the products to be
fried. Make sure the products to be fried are sufficiently dry. Shake deep-
freeze products above the sink to remove excess ice. Slowly lower the frying
basket in the frying fat, so that the moisture in the food is able to
evaporate. If you do not do this, the frying fat may splash.
Always fry without a cover. This prevents the fryer from overheating and
switching off automatically. At the same time, it ensures a more crispy frying
result.
Once the products to be fried are ready, you can lift the frying basket, shake
it lightly and hang it from the hook to allow the fat to leak.
Serve the dishes and hang the basket back in the fryer.
AFTER DEEP-FRYING
When you are ready with deep-frying you can fully turn back the thermostat knob and remove the plug from the socket.
ASSEMBLY OF THE BASKET
Once the frying fat has fully cooled down, you can fold the handle of the
frying basket to the inside, lower the basket and place the cover back on the
fryer. See the drawings below
Allow the fryer to cool down for a number of hours before moving it. When
moving the fryer, always use both hands and always use the handles on both
sides of the fryer
TIPS
- Caution: during and after deep-frying it is possible that drops of condensation fall in the hot frying fat. The loud noise that you can hear is the reaction of the liquid to hot frying fat, which is normal. It does not have an effect on the operation of your fryer.
- Caution: when deep-frying fish, meat and dough products, we recommend lowering the empty frying basket in the reservoir and only then place the products to be fried in the frying basket. This prevents the products from sticking to the frying basket.
- To prevent early contamination of the frying fat, the products should not be salted prior or during deep-frying.
- For a good result it is recommended to not fully fill the frying basket (maximum 500 grammes). For frozen fries it is recommended to use smaller portions, as these contain more liquid and could otherwise cool down the frying fat too much. It is also possible that the frying fat starts to foam violently and could overflow.
- When making fresh fries from potatoes, you must properly dry the fries after washing so that no liquid gets into the frying fat.
Fry the fresh fries two times. The first time (pre-frying) 5 to 10 minutes at 170 degrees. Allow the fries to leak and cool for a few minutes. For the second time (final frying), set the thermostat knob to 190 degrees and finish frying the fries in 2 to 4 minutes. Allow to leak properly after deep-frying.
SAFETY
Your fryer has been provided with a double safeguard, i.e. a reset button and
a safety switch.
The fryer has been provided with an anti-overheating safeguard that ensures
that the fryer switches off automatically when it gets overheated. Remove the
plug from the socket and allow the fryer to cool down fully. You can switch on
the fryer again by pressing the reset button located on the rear of the cord
storage compartment. See the image at the product description.
Take a round blunt object and use it to press the reset button in the round
opening at the rear of the element.
On the front of the element of the fryer there is a safety switch that ensures
that the heating element is immediately switched off when the element is
removed from the fryer while the fryer is still on. Moreover, this safeguard
ensures that the element cannot be switched on if the heating element is not
placed properly in the guides.
If your fryer does not work, we recommend checking the above-mentioned
safeguards.
CLEANING AND MAINTENANCE
FILTERING OR REPLACING LIQUID FRYING FAT
Before you start filtering or replacing frying fat, you must allow the fryer
to cool down fully and remove the plug from the socket. Regular filtering of
the frying fat considerably increases the life span of the fat. Replacing the
frying fat is recommended after deep-frying 8 to 12 times.
The frying fat should be filtered while cold. Pour the frying fat in a clean
dish, clean the reservoir with hot water and a little washing-up liquid or in
the dishwasher. Properly dry the reservoir. When pouring the frying fat back
in the reservoir, let the frying fat run through a fine sieve. When replacing
the frying fat, observe the same actions. Check each time that the level of
the frying fat is between minimum and maximum. Used liquid frying fat can be
poured back in the bottles. Never flush away frying fat in the sink.
CLEANING THE FRYER
Before cleaning the fryer, you must allow the fryer to cool down fully and
remove the plug from the socket. Remove the cover, frying basket, element and
reservoir from the fryer. Clean the cover, frying basket and reservoir in the
dishwasher or with hot water and a little washing-up liquid. Make sure the
parts are properly dried after cleaning. You can clean the exterior of the
fryer with a damp cloth to which a little bit of washing-up liquid has been
added.
Do not use aggressive or abrasive agents for cleaning the appliance. Never
submerge the element, cord or plug in water or other liquids.
Recycling
This symbol means that this product should not be disposed of with regular
household waste (2012/19/EU). Observe the applicable rules in your country for
the separated collection of electric and electronic products. By disposing of
the product correctly, you prevent negative consequences for the environment
and for public health. The packaging material of this product can be recycled
100%, return packaging material separately
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>