TELTONIKA RUT230 3G Router User Guide
- June 7, 2024
- teltonika
Table of Contents
TELTONIKA RUT230 3G Router
FRONT VIEW
BACK VIEW
POWER SOCKET PINOUT
HARDWARE INSTALLATION
-
Push the SIM holder button with the SIM needle.
-
Pull out the SIM holder.
-
Insert your SIM card into the SIM holder.
-
Slide the SIM holder back into the router.
-
Attach all antennas.
-
Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
-
Connect to the device wirelessly using SSID and password provided on the device information label or use an Ethernet cable connected to LAN port.
-
\nter the router’s Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser.
-
Use login information shown in image A when prompted for authentication.
-
After you login, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters, including at least one uppercase letter, one lowercase letter and one digit. This step is mandatory and you will not be able to interact with the router’s WebUI before you change the password.
-
When you change the router’s password, the Configuration Wizard will start. The Configuration Wizard is a tool used to setup some of the router’s main operating parameters.
-
Go to Overview page and pay attention to the Signal Strength indication (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.
TECHNICAL INFORMATION
Radio specifications
RF technologies| 2G, 3G, WiFi
Max RF power| 33 dBm@GSM, 24 dBm@WCDMA, 20 dBm@ WiFi
**Bundled accessories specifications*
Power adapter| Input: 0.4A@100-240VAC, Output: 9VDC, 1A, 4-pin plug
Mobile antenna| 698~960/1710~2690 MHz, 50 Ω, VSWR<3, gain 3 dBi,
omnidirectional, SMA male connector
WiFi antenna| 2400~2483.5 MHz, 50 Ω, VSWR<2, gain** 5 dBi, omnidirectional,
RP-SMA male connector
SAFETY INFORMATION
RUT230 router must be used in compliance with any and all applicable national
and international laws and with any special restrictions regulating the
utilization of the
communication module in prescribed applications and environments.
Hereby, TELTONIKA declares that this RUT230 is in compliance with the essential requirements and other relevant provisions of Directive CE/RED.
The full text of the EU declaration of conformity is available at the
following internet address: https://wiki.teltonika-
networks.com/view/RUT23
www.teltonika-networks.com
References
- Teltonika Networks - LTE Routers, Gateways & Modems for IoT
- wiki.teltonika-networks.com/
- RUT230 - Teltonika Networks Wiki
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>