EDIFIER Headphones Bluetooth Stereo Headphone Instruction Manual

W806BT
Headphones Bluetooth Stereo Headphone
Operating instructions

Overview

Before using the headphone, please carefully read this user manual and keep it for further reference.
Features

•  Headband wireless headphones, fashionable and portable
• CSR technology with Bluetooth V4.0 for low power and high-efficiency transmission
• Big capacity Li-battery supports standby 800 hours and working 35 hours
• Φ40mm NdFeB unit for high resolution and graceful sound
•  Ergonomic earlap design matches soft leather earcup and cushion for comfortable wear
•  With automatically switching wire and wireless control

Specification

Note: Design and specifications are subject to change without notice.

Instruction

1. Illustration

Box content: Headphoneⅹ1 3.5mm audio cableⅹ1 USB charging cableⅹ1
User manualⅹ1

Operation

Recharging

During use, when you see the red light flashing, it means the battery is low and you need to recharge the headphone.
Red light on = Charging Red light off = fully charge
Recharging time: approx 3 hours.
Tips: W806BT headphones take a special design with a short micro USB connect port based on the PCBA requirement, it is normal that some plug parts exposing out when in charging.
Warning: The rechargeable batteries providing power for the product must be properly disposed of for recycling. Do not place the batteries into the fire to prevent an explosion.

On/Off

flashing alternately

Pairing

1. Power on the headphone, press, and hold the multi-function key for about 5 seconds until the red and blue lights flash alternately, the headphone enters into pairing status.
2.  Enable Bluetooth function on your mobile phone and search Bluetooth devices. Select “ EDIFIER W806BT ” to pair and connect. When successfully connected, the blue light of the headphone flashes slowly and the headphone has a prompt tone.

Function operation

volume
Volume decrease| Press volume decrease key| –
Next track| Press and hold volume increase  key| –
Previous track| Press and hold the volume decrease key| –
Call| Incoming| | Have continuous beep prompt tone
Answer/end| Press multi-function key| Have a beep prompt tone
Reject| Press and hold multi-function    key where incoming a call| Have two beeps prompt tone
 Last number dial| press and hold multi-function key| Have to extend beep prompt
tone
Enable voice function| Press multi-function key twice| –
Restore factory setting| Press and hold volume increase/decrease key| Blue light quickly flashes three times

Note:

1.  When using a 3.5mm audio cable connecting, the headphones isinOFF status, and the operation key has no function.
2. Enable voice function needs your mobile phone having voice function and in ON status.
3. Remote play control (previous track/next track/pause/play) function needs your mobile phone supporting AVRCPprotocol

Maintenance and repair

• During usage, please read the following suggestions which would help you follow the warranty terms and make the product life

• Keep the product dry and far from any damp places in order to avoid the effect on the product’s internal
  You should avoid using the product during intense exercise or when you sweat too much.

• Do not place the product directly under the sun or where the temperature is High temperature will shorten the electronic components’ life and damage batteries.

• Do not put the product in very cold places in order to prevent its internal circuit board from being

• Do not dismantle the product. Non-technician may damage the product.

• Do not drop, violently vibrate or strike the product with hard items in order to prevent its internal circuit from being damaged.

• Do not use strong chemical products or detergents to clean the headphone.

• Do not use any sharp items to scratch the product surface in order to prevent its casing from being And its outlook from being affected.

• If the product cannot work properly, please send it to your qualified service The staff shall help you with their whole heart.

FAQs

1.  The red light flashes instead of the blue light. Answer: It means the headphone battery has low power. You need to recharge the headphone.

2. The red light is off when charging. Answer: a. Please ensure the connection between the charging device and the headphone works well. b. The batteries would be in the state of hibernating if the headphone is not in use for a long time. It needs to be recharged in about 30 minutes. By then the red light will be on.

3.  You cannot hear anything from the headphone. Answer a. Make sure the headphone is ON. b. Make sure the headphone’s volume is correct. c. Make sure the headphone is properly connected with your mobile. d. Make sure if the headphone is too far away from your mobile or there is any interfere device nearby.

4. The call quality is not good.
   Answer a. Make sure if your mobile is in the area having a strong signal.
   b. The effective work range of the headphone is 10 meters. Make sure the headphone is within the effective work range and there are no obstacles between the headphone and your mobile.

5. Whycannotthe headphones pause, resume, go previous and next track when playing music.
   Answer: These functions need the devices being paired with the headphone to support AVRCP protocol (Audio/VideoRemoteControlProfile).

CAUTION

The danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.
A warning that batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as sunshine, fire, or the like.

1. “To prevent possible hearing damage, do no this tenant high volume levels for long periods.”
2. “Fully understand user manual before use.”
3.  “Ensure your player at low volume levels or power off before you leaving.”

Correct Disposal of this product. This marking indicates that these products should not be disposed of with another household disposal, recycle responsibly to promote the sustainable reuse of materials sources. To return your used device, please use their turn and collection systems or contact t the retailer where the product was purchased. They can take this product for environmentally safe recycling.

Warning!

• To guarantee your personal safety, please do not work keep earphones in the vicinity(closer than 10cm) of a pacemaker.
• Do not insert the plug into electric sockets.
• Supervise children when using the equipment, the product is not a toy.
• Earphone listening to high volume levels — particularly, over extended periods of time—may damage your hearing.
• The operation of the witches sonyourhi-fi system or plugging in the earphones may cause clicks which at high volume settings may affect our hearing. Therefore, always set the volume control to a minimum before switching between different sources (tuner, turntable, CD player, etc.) or plugging in the earphones.
• For traffic safety, do not use earphones while driving or cycling.

Customer Service

If any issues or needs when using the headphone, please feel free to CONTACT US via email: esaleader.hk@gmail.com. We’re always here ready to help, will get back to you in 12 hours.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>