OUTDOOR TECH OT0053 CHIPS 3.0 Bluetooth Snow Helmet Speakers User Manual
- June 6, 2024
- OUTDOOR TECH
Table of Contents
OUTDOOR TECH OT0053 CHIPS 3.0 Bluetooth Snow Helmet Speakers
Good call on picking up the Outdoor Tech® CHIPS® 3.0 , universal wireless
helmet audio. Your experience of the universe will soon be enhanced
wirelessly. This manual exists to help make sure that you use them correctly,
so you’re definitely going to want to relax for a hot second and look through
this manual.
Kisses,
ANATOMY
- A. Left ear button
- B. Right ear button
- C. Charge port USB-C
- D. LED light
- E. Microphone
FUNCTIONS
POWER UP
- For best results, fully charge your CHIPS® 3.0 using the supplied USB to USB C charging cable before use.
- The indicator light located on the right ear piece will flash red to indicate a low battery.
- Once the Chips 3.0® are plugged into a power source, the indicator light will turn red. It will turn off once the CHIPS are completely charged.
NOTE: It only takes 45 minutes to give your CHIPS® 3.0 a full charge.
PAIRING
(From the OFF position press and hold until LED flashes red and blue
alternately.)
VOICE PROMPT: “power on>>pairing” Choose: “ODT Chips® 3.0” in your phone’s
Bluetooth settings.
VOICE PROMPT: “connected”
(If prompted by your device to connect, select “Yes”. If prompted by your
device enter password or use pairing code: 0000.)
TALK
The following are tips on how to use your CHIPS® 3.0 to speak on the telephone:
-
Answer a call
Press right ear button -
End a call
Press right ear button -
Reject a call
Press and hold the right ear button for two seconds -
Make a call
Use your phone to dial as usual
Listen & talk through the CHIPS® -
Volume up
Double press the left ear button -
Volume down
Press left ear button -
Voice Activation
Press and hold both left and right ear buttons simultaneously.
Release and speak when you hear the voice prompt: “Beep”.
PUT THE CHIPS IN YOUR HELMET
Drop the CHIPS® 3.0 into the slots inside your helmet liner. Rock out, make calls, and, you know, ski and snowboard and whatnot.
SPECS
-
Battery life
13 hours of play time
*Battery life varies subject to different playing circumstances, such as music type and volume. -
Bluetooth version
V5.2 -
Bluetooth profiles
HFP1.8, HSP1.2, A2DP1.3, -
AVRCP1.6 Operating distance
33 feet, 10 meters -
Charging input
DC 5.0V, 1A -
Dimensions
2” diameter, 0.5” thick -
Weight
0.18 lbs (81.6g) -
Battery capacity
250mAh
FAQ
Why is the red LED flashing twice every 20 seconds?
The battery is low. Recharge it.
Why is the red LED off when charging?
A. Make sure the connection between the charging cable and the CHIPS® 3.0
is tight.
B. If the CHIPS® 3.0 haven’t been used in awhile, the light may not come
on immediately. Charge the battery for at least 30 minutes.
Why can’t I pair my CHIPS® 3.0?
A. Your Bluetooth device and the CHIPS® 3.0 must both be in pairing mode.
B. Your CHIPS® 3.0 should not be paired to any other devices.
Why do I have Bluetooth signal loss/dropout/unclear conversations?
A. Move your device closer to your CHIPS® 3.0.
B. Make sure your CHIPS® 3.0 are charged up.
C. Turn off your CHIPS® 3.0 and device, then power up and reconnect.
Why can’t the CHIPS® 3.0 hear my voice during a call?
A. Make sure the CHIPS® 3.0 are on.
B. Make sure the volume is not too low or muted.
C. Make sure the CHIPS® 3.0 are properly connected with your device.
D. Make sure the CHIPS® 3.0 are within range of your device.
CARE & MAINTENANCE
- Keep the CHIPS® 3.0 dry
- Keep the CHIPS® 3.0 away from direct sunlight or hot places. High temperatures will shorten the life of electronic devices, destroy the battery or distort certain plastic parts.
- Do not try to disassemble the CHIPS® 3.0.
- Do not let the CHIPS® 3.0 fall onto the floor or other hard surfaces. The internal circuit board may get damaged.
- Do not use intensive chemical products or detergent to clean the product.
- Do not scratch the surface with sharp things.
DON’T BE SO ANTISOCIAL
- Facebook.com/outdoortechnology
- Twitter.com/@outdoortech
- Instagram.com/@outdoortech
- www.outdoortech.com