HYDROPOOL 5530050 Filter Housing Front Cover Installation Guide
- June 16, 2024
- HYDROPOOL
Table of Contents
HYDROPOOL 5530050 Filter Housing Front Cover
Specifications
- Product Name: Filter Grill Installation for 2024 Signature
- Models
- Part Numbers:
- P/N: 5530050 – Filter Housing Cover Front
- P/N: 2005117 – Grill Brace
- P/N: 2005187 – Screws
- P/N: 5530053 Filter Housing Cover Top
- P/N: 5530051 – Filter Housing Clips
- P/N: 2010020 – Washer
Step 1: Filter Housing Cover Assembly
Both L-shaped holders need to be installed using screws and washers. Ensure the orientation of the holder is correct with the curved edge outside.
| Hydropool Standard Work Instructions
---|---
TITLE: FILTER GRILL INSTALLATION FOR 2024 SIGNATURE MODELS
Process Description: Filter Grill Covering| Revised Date| 19-Mar-24
Created by| Sagar Surendran| Approved by| John Tumanguil
ID#| Process name| Method
P/N: 2005117 – Grill Brace P/N: 2005187 – Screws
P/N: 5530050 – Filter Housing Cover Front
P/N: 2010020 – Washer
P/N: 5530053 Filter Housing Cover Top P/N: 5530051 – Filter Housing Clips
Installation
Equipment Requirements
Step 1| Filter Housing Cover Assembly| Using the screw and washer, install the following behind the filter grill cover:
(1) The L-shaped holder on both sides of the filter grill cover
(2) The curved holder at the bottom of the filter grill
cove
Both L-Shaped holders need to be installed using screws and washers.
(1) Ensure the orientation of the holder is correct: Curved edge
outside.
(2)
Step 2| Installing Filter Housing Cover| Install the assembled filter
grill cover onto the spa. Ensure all 3 clips of the front grill are properly
secured in their respective locations on the filter grill and can be adjusted
left and right to fit into the clip on the spa if required
---|---|---
Step 3| Installing Roof Cover| Roof Cover needs to be secured
properly on the top. The locking pin underneath the roof cover must be pushed
into the slots on the assembled grill cover.
Locking pin Locking pin slot location Pin to be secured into the slot Roof
cover secured – Top View
Step 4| Final Check| Cover the assembly with a protective wrap. Ensure there are no excessive gaps around the filter recess shroud.
Step 2: Installing Filter Housing Cover Clips
Clips on the filter grill can be adjusted left and right to fit into the clip on the spa if required. The roof cover needs to be secured properly on the top. The locking pin underneath the roof cover must be pushed into the slots on the assembled grill cover.
Step 3: Installing Roof Cover
Cover the assembly with a protective wrap. Ensure there are no excessive gaps around the filter recess shroud.
Step 4: Final Check
Ensure all 3 clips of the front grill are properly secured in their respective locations. Check that the assembly is properly installed and secured.
FAQs
Q: How do I adjust the clips on the filter grill?
A: The clips on the filter grill can be adjusted left and right to fit into
the clip on the spa if required.
Q: What should I do if there are excessive gaps around the filter recess
shroud?
A: Ensure that the assembly is covered with a protective wrap to minimize any
gaps around the filter recess shroud.