FEIT ELECTRIC 3580142 Wireless Chime for Smart Doorbells Installation Guide
- June 6, 2024
- Feit Electric
Table of Contents
FEIT ELECTRIC 3580142 Wireless Chime for Smart Doorbells
Limited Warranty
This product is warrantied to be free from defects in workmanship and materials for up to 1 year from date of purchase. If the product fails within the warranty period, please contact Feit Electric at info@feit.com, visit feit.com/contact-us or call 1-866-326-BULB (2852) for instructions on replacement or refund. REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY EXCLUDED. Some states and provinces do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state or province to province.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help. Any changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable exposure condition
without restriction.
The device can be used in mobile (min 7.87 in.) exposure condition without
restriction.
S upplier’s Declaration of Conformity : 47 CFR § 2.1077 Compliance
Information
Responsible Party:
Feit Electric Company
4901 Gregg Road,
Pico Rivera, CA 90660, USA
562-463-2852
Unique Identifier:
CHIME/DOOR/SMART
Pre-Installation
HARDWARE INCLUDED
Description
App Setup
Supply power to your Wireless Chime (AA) with the USB power adapter near the Smart Doorbell. You can relocate it after pairing the device .
2 Open the Feit Electric app.
3 Tap on your Smart Doorbell to open
4 Tap the pen icon located at the upper
5 Tap “Bell” under Settings.
6 Tap “Chime Type” then choose
NOTE : The USB power adapter is not included.
7 Press the Reset Button on the Wireless Chime (AA) to put the Wireless Chime (AA) in pairing mode for 30 seconds.
8 Tap “Add” in the app or press the Doorbell Button on your Smart Doorbell. The Status Light on the Wireless Chime will stop blinking, confirming that it has been paired to your Smart Doorbell.
NOTE : If setup was not successful, press and hold the Reset Button for 5 seconds to reset the Wireless Chime to factory settings. The BLUE status light will blink rapidly for 2 seconds to confirm that it has been rest.
9 You can choose from 4 different ringtones and adjust the volume.
10 The Wireless Chime will play a ringtone to alert you when the Smart Doorbell button is pressed.
NOTE: The Wireless Chime has a transmitting range up to 150 feet of the Smart Doorbell. One Smart Doorbell can control multiple Wireless Chimes.
Need Help?
Thank you for your purchase. Questions, comments or feedback? We’d love to
hear from you. Visit feit.com/help for support or connect with us:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>