TOZO PA1 Portable Bluetooth Speaker User Manual

June 3, 2024
TOZO

TOZO PA1 Portable Bluetooth Speaker

TOZO-PA1-Portable-Bluetooth-Speaker-PRODUCT

Safety Instructions

  • This product contains magnetic material. Please consult your doctor about whether it will affect implantable medical devices.
  • Please place this product away from sources of fire and heat. Do not place an open flame source (such as a lit candle) on or near this product.
  • Do not modify the product without authorization.
  • Do not use this product with an inverter.
  • Only use this product with a power supply that has been approved by the relevant authorities and meets local regulatory requirements (e.g. UL, CSĄ, VDE, CCC).
  • The batteries included with this product may pose a fire or chemical burn hazard if not handled properly.
  • Do not overheat the product containing the batteries (e.g, keep out of direct sunlight and away from sources of ignition, etc.).
  • If the speaker is exposed to salt or chlorinated water, rinse it gently with fresh water afterward to remove the residue.
  • Before charging, make sure the connector port is completely dry.
  • Do not charge the speaker when it is wet.

Product Description

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-1

Specifications

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-7

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-8

Key function guide

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-2

  • X1: Press once
  • Hold: Press and hold for 1.5 seconds
Bluetooth pairing

Short press BT key Blue light flashing fast (light 250ms, off 250ms)

  1. For the first time to boot into pairing mode, blue light fast flashing, blue light is always on after connecting the device successfully.
  2. When there is a pairing history, power on into the back connection mode blue light slow flashing (light 500ms, 500ms of), short press BT key to enter the pairing mode, Bluetooth pairing time for 5 minutes, pairing failure after shutdown.
  3. Bluetooth connection status, short press the BT key, and disconnect the Bluetooth connection into the pairing state.

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-4

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-5TWS function guide

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-6

  1. After the speaker is turned on, connect this speaker with cell phone Bluetooth.
  2. Then the speaker long press Bluetooth key 5S to enter the TWS group state.
  3. Prepare another speaker on and in the pairing state can automatically connect with the first speaker.

Solutions to common problems

  • If there is a problem with the speaker.
  • Power on the speaker.
  • Check the status of the status indicator.
  • Make sure the mobile device supports Bluetooth technology.
  • Charge the battery.
  • Turn up the volume on the speaker, device, and music app.
  • If necessary, the product can be restored to the factory settings.
  • Move the device closer to the speaker and away from other distractions or obstructions.

If you cannot solve the problem, see the table below for symptoms and solutions to common problems.
If you are still unable to resolve the problem, please contact TOzo Customer Service.
Please visit: www.tozostore.com

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-9

TOZO-PA1-Portable-Bluetooth-Speaker-FIG-10

Disclaimers

TOZO has the final authority to interpret this manual. Design and specifications are subject to change without notice.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Thank you for purchasing the TOZO authentic product.
For more latest products, parts and accessories,
please visit: www.tozostore.com
For any assistance please contact Email: info@tozostore.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals