NEXA Remote Control Instructions

: June 7, 2024
: NEXA

Table of Contents

Overview
PROGRAMMING
PROGRAMMING CONFIRMATION
DELETING MEMORY
CONFIRMATION OF DELETION
Safety and information
TECHNICAL DATA
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**NEXA Remote Control Instructions

LYCT-705**

Overview

The remote control has 16 channels divided into 4 groups. Use the Group ON/Group OFF button to switch all the channels in a group on or off.

PROGRAMMING

Receiver without button for programming.

Connect the receiver (plug-in) to a power socket. The receiver goes into setup mode as soon as it is powered up.
Press the “ON” button for the selected channel on the remote control within 6 seconds.

Receiver with button for programming.

Connect the receiver (plug-in) to a power socket. Activate set-up mode with a short press on the button for programming, LED indication on the receiver flashes slowly.
Press the “ON” button for the selected channel on the remote control within 6 seconds.

PROGRAMMING CONFIRMATION

The LED indicator on the receiver flashes rapidly. If a light is connected to the receiver, this flashes twice.

DELETING MEMORY

Receiver without button for training.

To delete a memory slot, remove the receiver (plug-in) from the wall socket
Wait at least 6 seconds
Reconnect the receiver to a wall socket
Press the “OFF” button for the selected channel on the remote control within 6 seconds.

To delete all memory slots, repeat steps 1-3 above, then press the “ALL OFF” button on the remote control within 6 seconds.

Receiver with button for programming.

Activate setup mode with a short press on the receiver’s button for programming, LED indication on the receiver flashes slowly.
Press the “OFF” button for the relevant channel on the remote control within 6 seconds.

To delete all memory slots press and hold in the receiver’s button for programming, for at least 6 seconds, until LED indication on the receiver flashes rapidly, then press briefly on button for programming again.

CONFIRMATION OF DELETION

The LED indicator on the receiver flashes rapidly. If a light is connected to the receiver, this flashes twice.

Safety and information

Indoor range: up to 30 m (optimal conditions). The range is strongly dependent on local conditions, such as the presence of metals. For example, the thin metal coating in Low-emissivity (Low-E) glass has a negative impact on the range of radio signals. There may be restrictions on the use of this device outside the EU. If applicable, check whether this device complies with local directives.

Maximum load: Never connect lights or equipment that exceed the maximum load of the receiver, as it can result in defects, a short circuit or fire.

Life-support: Never use Nexa products for life-support systems or other applications in which equipment malfunctions can have life-threatening consequences.

Interference: All wireless devices may be subject to interference, which could affect performance. The minimum distance between 2 receivers should be at least 50 cm.

Repairing: Do not attempt to repair this product. There are no user- serviceable parts inside.

Water-resistance: This product is not water-resistant. Keep it dry. Moisture will corrode the inner electronics and can result in a short circuit, defects and shock hazard.