ULINE 5/8″ High Performance Glue Gun H-3129 User Manual
- June 7, 2024
- ULINE
Table of Contents
ULINE 5/8″ High Performance Glue Gun H-3129 User Manual
TOOL INCLUDED
Screwdriver (Built Into Base)
OPERATION
NOTE: The glue gun should be unplugged after each use. The adhesive can be stored indefinitely in the unheated gun and re-melted by heating up the tool.
-
Use built-in screwdriver to adjust temperature control.
NOTE: The glue gun comes pre-set at 375°F. -
Plug the glue gun into a 120 volt AC outlet; when red light illuminates on/off switch, the power is on.
-
Insert 5/8″ glue stick into glue feed. Allow the glue gun to heat for approximately 3 to 5 minutes.
CAUTION! Once glue gun heats up, the nozzle and melted glue are extremely hot. Avoid touching. -
When the gun is fully heated, squeeze trigger slowly.
The melted glue will begin to flow from nozzle.
Release the trigger to stop the glue flow. -
The output volume of the glue can be adjusted by turning the stroke adjuster clockwise.
NOTE: Use short nozzle for general use or long nozzle for harder to reach areas. -
If glue drips excessively, replace the nozzle. To change, heat the gun for a minute until glue is softened enough to remove the nozzle. While wearing gloves, use a wrench to remove the old nozzle. Flush glue through the gun and attach the new nozzle.
SAFETY INSTRUCTIONS
- Keep out of reach of children.
- Never touch the gun’s nozzle or the melted glue. Operating temperatures reach 450°F and can cause severe burns. Immediately immerse any accidental burns in cold water and seek medical attention.
- Do not use within 10 feet of flammable materials.
- Not for outdoor use or in areas that may be wet or damp.
- Keep all work areas clean and well lit.
- Never use with materials other than recommended glue sticks.
- Always wear protective safety equipment such as gloves, glasses, and long sleeve shirts and pants when using.
- When inserting glue sticks in glue gun, avoid using too much force.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent to avoid a hazard.
- Always follow basic safety precautions when operating.
Support
Tel: 1-800-295-5510
Website: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>