NERF 1228-7 Wrist Walkie Talkie Instruction Manual
- June 3, 2024
- NERF
Table of Contents
NERF 1228-7 Wrist Walkie Talkie
Thank you for purchasing your Nerf Wrist Walkie Talkies. You can use your walkie talkies to easily talk to your friends and look at the built-in watch to view the current time. For best results, read this instruction manual first before using.
PACKAGE CONTENTS
- Two Wrist Walkie Talkies
- 12pcs AG10 batteries
- Instruction Manual with Warranty Information
FEATURES
- Stay in touch with your friends!
- Perfect for indoor and outdoor play!
- Push-to-talk button and ON/OFF switch
- Built-in watch
- Each uses 6pcs AG10 batteries (included)
INSERTING BATTERIES
Each walkie talkie requires 6 AG10 batteries for power. When first using your walkie talkies pull out the paper tab covering the battery compartment.
To insert or replace batteries, use a screwdriver to remove the screw on the battery compartment door. Note that the battery compartment is located on the rear of each walkie talkie. Once the battery compartment is open, insert batteries with the correct polarity(+,-) as displayed in the battery compartment. After the batteries havebeen inserted, close the battery compartment, and once again use a screwdriver to screw the battery compartment door in place.
USING YOUR WALKIE TALKIES
Once batteries are inserted you can follow the steps below to use your walkie talkies:
- Slide the ON/OFF switch on each walkie talkie to the ON position.
- Hold one walkie talkie close to your mouth.
- Press the PUSH TO TALK button, and speak clearly to transmit a message to the other walkie talkie.
- Release the PUSH TO TALK button when you are finished talking so that you can hear any in coming messages from the other walkie talkie.
- When you are finished using your walkie talkies, slide the ON/OFF switch on each walkie talkie to the OFF position to power them off.
BATTERY WARNING:
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickle-cadmium) batteries.
- Batteries are not to be inserted with the wrong polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
Please recycle or dispose of the battery properly. Contact local recycling facilities and/or the manufacturer of your battery for further lnformation
USING THE WATCH FEATURE
Lift open the cap to reveal the built-in watch.
Press the MODE button continuously to toggle through time, date and stop watch
modes.
In time mode, the current time will be shown on the display screen.
In date mode, the current date will be shown on the display screen.
When in time mode, press the SET button two times to enter settings mode.
In settings mode, you can change the value of the current setting by pressing
the MODE button, and confirm your setting and move on to the next selection by
pressing the SET button.
The settings mode will let you adjust the following settings:
MONTH–>DATE–>HOUR–>MINUTE
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference , and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates. Uses and can radiate radio
frequency energy and, if not installed and used in accordance with
instructions. May cause harmful interference to radio or -television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:!
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/ 1V technician for help.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in the portable exposure condition without restriction
One Year Warranty
This warranty covers the original consumer purchaser only and is not transferable. This warranty covers products that fail to function properly UNDER NORMAL USAGE, due to defects in material or workmanship. Your product will be repaired or replaced at no charge for parts or labor for a period of one year.
What Is Not Covered by Warranty
Damages or malfunctions not resulting from defects in material or workmanship
and damages or malfunctions from other than normal use, including but limited
to, repair by unauthorized parties, tampering, modification or accident. To
obtain Warranty Service and Troubleshooting information:
Call 1-877-397-8200 To receive Warranty
service along with the name and address of an authorized product service
center, the original consumer purchaser must contact us for problem
determination and service procedures. Proof of purchase in the form of a bill
of sale or receipted invoice, evidencing that the Product is within the
applicable Warranty period(s), MUST be presented in order to obtain the
requested service. It is your responsibility to properly package and send any
defective products along with a dated copy of proof of purchase, a written
explanation of the problem, and a valid return address to the authorized
service center at your expense. Do not include any other items or accessories
with the defective product. Any products received by the authorized service
center that are not covered by warranty will be returned unrepaired.
WARNING:
CHOKING HAZARD This article contains small parts which pose a hazard to
children under 3 years.
