TELTONIKA TRB140 Networks Wiki User Guide

: June 7, 2024
: teltonika

Table of Contents

TELTONIKA TRB140 Networks Wiki User Guide
FRONT VIEW
HARDWARE INSTALLATION
DEVICE CONFIGURATION
TECHNICAL INFORMATION
SAFETY INFORMATION
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TELTONIKA TRB140 Networks Wiki User Guide

FRONT VIEW

BACK VIEW

POWER SOCKET PINOUT

HARDWARE INSTALLATION

Unscrew two back panel hex bolts.
Remove the back panel.
Insert your SIM card into the SIM socket.
Attach the panel and tighten the hex bolts.
Attach the mobile antenna (max torque 0.4 N·m / 3.5 lbf·in) and connect the USB cable.

DEVICE CONFIGURATION

Power on the device and connect the USB cable to your computer.
Allow the gateway to boot up. This might take up to 30 seconds.
Your computer’s OS should detect the USB device and install the driver.
To enter the gateway’s Web interface (WebUI), type http://192.168.2.1 into the URL field of your Internet browser.
Use login information shown in image A when prompted for authentication.
After logging in pay attention to the Signal Strength indication displayed in the Mobile widget (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.

TECHNICAL INFORMATION

Radio speciﬁcations

RF technologies| 2G, 3G, 4G
Max RF power| 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE
Bundled accessories **speciﬁcations*
Power adapter| Input: 0.4A@100-240VAC, Output: 9VDC, 0.5A, 4-pin plug
Mobile antenna| 698~960/1710~2690 MHz, 50 Ω, VSWR<2, gain 2 dBi, omnidirectional, SMA male connector

*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.

SAFETY INFORMATION

TRB140 gateway must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments

[EN] English| Hereby, TELTONIKA declares that this TRB140 is in compliance with the essential requirements and other relevant provisions of Directive RED.
---|---

Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.2.1 in your web browser to configure it. More information on https://wiki.teltonika-networks.com/The full text of the EU declaration of conformity is available at the following
internet address: https://wiki.teltonika-networks.com/view/TRB140

This sign means that all used electronic and electric equipment should not be mixed with general household waste.

This sign means that product meets the requirements of the applicable EU directives.