SATCO NUVO 65-534R1 LED Medium Flood Lights Instruction Manual

SATCO NUVO 65-534R1 LED Medium Flood Lights Instruction Manual

ELECTRICAL REQUIREMENTS:

• The LED driver must be suplied with 120 or 277V, 50/60 Hz and connected to an individual, properly grounded branch circuit protected by a 20 ampere circuit breaker. Use min. 75°C supply.

GROUNDING INSTRUCTIONS:

• The grounding and bonding of the overall system shall be done in accordance with NEC Article 600 and local codes.

TOOLS REQUIRED:

•  Crescent Wrench, Wire Strippers and Wire Cutters

WIRING DIAGRAM

WARNING:

• To reduce the risk of personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture and all fixture

• Commercial installation, service and maintenance of luminaries should be performed by a qualified licensed electrician. For the installation: If you are unsure about the installation or maintenance of the luminaries, consult a qualified licensed electrician and check your local electrical code.

• Turn off electrical power at fuse or circuit breaker before wiring fixture to the power supply.

• Turn off the power when you perform any

• All connections should be capped with UL approved wire

• Minimum size 18 AWG or 14 AWG for continuous

• Risk of Disconnect power and allow fixture to cool before handling.

• Verify that supply voltage is correct by comparing it with the luminaire label

• Do not install in a hazardous atmosphere, except where the ambient temperature does not exceed the rated operating temperature of the

• Keep tightly closed when in

INSTALLATION:

1. Before starting ensure that the power is

2. Unpack fixture and ensure that there are no damaged

3. Attach fixture to outdoor box cover, routing the fixture wires into the junction Connect fixture cables as seen in wiring diagram. Black to Black, White to White, and Green to Green.
   Aim fixture by loosening bolt on the arm, and repositioning to the desired angle. Tighten the bolt.

4. Wire end of cord to power supply as seen in wiring diagram.

Installation Instructions for Different Brackets

1.  1/2 ADJUSTABLE FITTER MOUNTING (1/2AM) (suitable for all power of

this series)

Step 1:Pass the wire through the metal sheet, the rubber mat, and the bracket (Figure 1).

Step 2:Lock the bracket and pass the wire through the other bracket (Figure 2).

Step 3:Lock the bracket (Figure 3).

2. TRUNION MOUNTING (TM) (suitable for all power of this series)

Step 1:Pass the input wire of the fixture through the bracket (Figure 4).
Step 2:Fix the bracket (Figure 5).

3.  YOKE MOUNTING (YM) (suitable for all power of this series)

Step 1:Take out the bracket. Tighten the screws. Fix the bracket on the figure (Figure 6).

Read More About This Manual & Download PDF:

Documents / Resources

| SATCO NUVO 65-534R1 LED Medium Flood Lights [pdf] Instruction Manual
65-534R1, 65-535R1, 65-536R1, 65-537R1, 65-538R1, 65-539R1, LED Medium Flood Lights, 65-534R1 LED Medium Flood Lights
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>