SATCO NUVO 65-781R1 Series LED UFO High Bay Light Installation Guide
- June 10, 2024
- SATCO NUVO
Table of Contents
SATCO NUVO 65-781R1 Series LED UFO High Bay Light Installation Guide
65-781, 65-782, 65-783, 65-784,
65-791, 65-792, 65-793, 65-794,
65-801, 65-802, 65-803, 65-804:
ø11 13/6″ (300mm)
65-784, 65-785, 65-787, 65-788,
65-795, 65-796, 65-797, 65-798,
65-805, 65-806, 65-807, 65-808:
ø14 3/16″ (360mm)
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
- To avoid damage, falling, electric shock or fire, do not modify the lamp or replace accessories without confirming with the supplier first.
- Only authorized, qualified personnel should install this fixture and should follow the owner’s manual. Any improper installation might cause failure, electric shock, fire or other injury, damage or hazard.
- Disconnect power before installation or any maintenance of the fixture.
- Do not dismantle the fixture without the supplier’s authorization.
- Do not touch the power supply when the fixture is operating.
- The external flexible cable or cord of this fixture cannot be replaced; if the cord is damaged, the fixture shall be destroyed.
- Terminal block not included. The electrical fitting must be installed by a licensed electrician.
- For use in environments where an accumulation of non-conductive dust on the fixture may be expected.
IMPORTANT: This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
SPECIFICATIONS
WIRING DIAGRAM & INSTRUCTIONS
The LED high bay light can be equipped with an optional DC motion sensor (86/218). The sensor needs to be set via remote (86/219). For standard 0-10V dimming, or Emergency Driver Integration applications, the dimming cable must be cut free from the integrated DC sensor port.
INSTALLATION: Hook Mount
STEP 1: Screw the hook into the fixture, tighten and secure.
STEP 2: Hang the fixture on the ceiling hook or chain.
STEP 3: Connect wires using the wiring diagram and instructions on page
- Make sure connections are capped and sealed.
INSTALLATION: Ceiling Mount
STEP 1: Use a pen or sharp tool and mark holes through the mounting surface on the ceiling and drill holes. Fix screws into the holes with a hammer.
STEP 2: Align the bracket hole with screw hole and push the fixture to one side and secure.
Optional DC Motion Sensor
© Copyright 2020 Satco Products, Inc. 12/20
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>