HUSKY LINERS Wheel Well Liners 79121 Installation Guide
- June 7, 2024
- HUSKY LINERS
Table of Contents
Part# 79121
wheel well liners
15-20 ford F150
LIST OF CONTENTS:
(A) 1 – Driver Side Wheel Well
(B) 1 – Passenger Side Wheel Well
TOOLS REQUIRED:
•Ratchet using 10mm socket in steps 3, 4 & 7.
Installation Instructions
Installation Video available @ huskyliners.com/79121
-
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION.
One person can perform the installation. -
VEHICLE PREPARATION:
It is important that all areas where the wheel wells mount are clean and free of debris prior to installation. -
For Trucks with Mud Flaps:
Remove mud flaps before installing wheel well liners. Then follow steps 4-8.
Re-install mud flaps. -
Start on the driver side using a ratchet with 10mm socket to remove the fastener toward the tail end of the wheel housing. (Save the fasteners).
-
Locate the two holes at the back area of the wheel housing and insert one J-Clip (C) in holes 1 & 2.
Note: Due to some variations in Super Duty trucks – you might have to turn J-Clip (C) sideways and hold it behind the metal flange because of the return lip at the bottom edge of wheel mouse flange near hole 2. -
Start on the driver side by setting the driver side wheel well (A) marked as (DS) inside the inner panel of the truck’s wheel well behind the tire.
-
Tuck the bottom sides of the lower part of the wheel well liner behind the metal lip of the truck’s fender and then tuck the upper part.
Then install two screws (D) provided in places 1 & 2 using a ratchet with a 10 mm socket. After that re-install, the two fasteners are saved in step 4 in places 3 & 4.
Note: Ford F150 application – No fastener toward cab to replace. -
Repeat steps 3-7 on the passenger side when installing the passenger side wheel well (B).
Installation Video available @
huskyliners.com/79121
View the Husky Liner Lifetime Warranty at www.huskyliners.com/lifetime-
warranty
21 Installation Instructions 6_14_2021