ULINE Monarch 1110 One Line Label Gun Instructions

: June 7, 2024
: ULINE

Table of Contents

INSTRUCTIONS
CHARACTER KEY
Contact Us
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ULINE Monarch 1110 One Line Label Gun Instructions

INSTRUCTIONS

CHANGE THE INK ROLLER

Turn latch to release ink roller door and carefully pull ink roller completely out of labeler. (See Figure 1)
Insert folded backing paper between ink roller and carrier. Pull to snap old ink roller free. (See Figure 2)
Cut off end of ink roller package. Using package to protect fingers, slide carrier into package and snap new ink roller into place. (See Figure 3)
Slide ink roller door back into place and turn latch to lock.
SET PRINT CHARACTERS
Pull knob until indicators are on the desired band. (See Figure 4)
Turn the knob until the desired character appears black on a white background between the indicators. (To print a blank, select the blank space for that band).
Repeat steps 1-2 for each band.
Push in the knob when you are done.

LOAD LABELS

For loading a new roll of labels, tear off and discard the first 10 inches of label and liner. Tear backing evenly between cuts.
Peel the first 12 labels from liner and discard.
Place the label roll between the hubs and click into place. (See Figure 5)
Squeeze and hold the trigger while feeding the label strip into the slot below the brake wheels until about 6 inches come out of the front . (See Figure 6)
Feed label strip under the plate and pull through until loop is removed. (See Figure 7)
Squeeze and hold the trigger while feeding the label strip into the slot below the arrow until it stops/hits the back. (See Figure 8)
Hold the strip in place and squeeze the trigger eight times or until label strip feeds through the rear exit. (See Figure 8)
Remove any loose labels.

NOTE: If backing paper does not become taut and exit at rear, turn labeler upside down, squeeze trigger and pull backing paper out of slot. Repeat steps 5, 6 and 7.

PRINT ADJUSTMENT

Print location is correct when extreme righthand and lefthand characters are located as shown.

Approx. 1/16 inch

Approx. 1/16 inch
Place small coin in feedwheel button slot. (See Figure 9)
Push feedwheel button in completely and turn slightly clockwise if print is too far left or slightly counterclockwise if print is too far right. Adjustments made without completely depressing button are temporary.
Repeat steps 2 and 3 until print is correctly aligned.

REMOVE SUPPLIES

Tear label strip at label roll as shown and pull label roll from between hubs. (See Figure 10 )
Tear backing paper strip. Pull label strip from labeler. (See Figure 11)
Squeeze and release trigger until backing paper is free to be pulled out. (See Figure 11)

CLEAR JAMS, CLEANING AND LUBRICATION

With label roll removed, check label track and backing paper track for stray labels.
Clear label track by squeezing trigger and feeding label removal strip under brake wheels and out front of labeler. (See Figure 12)
To clear backing paper track:
a. Insert label removal strip in end of track to loosen stray labels. (See Figure 13)
b. Insert label removal strip as shown, using corner to remove stray labels. (See Figure 13)
If adhesive buildup occurs, lubricate with one drop of a commercial 100% silicone lubricant as shown with labels loaded.