ULINE LD3500 Automatic Label Dispenser H-7206 User Guide
- June 7, 2024
- ULINE
Table of Contents
H-7206
LD3500 AUTOMATIC
LABEL DISPENSER
MAINTENANCE
- Turn machine off when not in use.
- Remove liner material from take-up hub when it reaches approximately 2″ in diameter or if the motor appears to be bestraininq.
- Do not operate if the inspection reveals a damaged power or sensor cord.
- Keep strip plate, hold-down, and hub free of adhesive buildup.
INSTRUCTIONS
NOTE: Machine must be unplugged from the power supply for steps 1 to 7.
- Lift reel holder arm at 90° angle and lock into position using provided hex (See Figure 1)
INSTRUCTIONS CONTINUED
-
Insert core holders into each side of the label roll.
-
Slide loaded a roll into reel hanger (See Figure 2)
NOTE: Labels should dispense from under the roll. -
Feed label liner under guide (See Figure 3)
-
Feed label liner between brush and strip plate. (See Figure 4)
-
Adjust hub lock for guiding material.
-
Slide lock rod off take-up hub. (See Figure 5)
-
Secure label liner onto take-up hub.
ADJUSTMENTS
-
To apply the proper amount of tension for proper label feeding and detection, loosen the brush wing screw and press down to increase tension, then tighten the screw. (See Figure 6)
-
Loosen wing screw, then adjust sensor plate.
-
Point sensor toward the top edge of the label; then, tighten wing screw to secure the sensor in place. (See Figures 7 and 8)
-
Connect power cord and press power switch to turn on. (See Figure 9)
1-800-295-5510
uline.com
0821 IH-7206
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>