ULINE WALL-MOUNT Coat Rack H-2515 User Guide
- June 7, 2024
- ULINE
Table of Contents
H-2515
WALL MOUNTED COAT RACK
1-800-295-5510
ulink.com
**TOOL NEEDED
**
PARTS
**ASSEMBLY
**
-
Open both H-25158 and H-2515A boxes and arrange parts on a flat surface as shown in Figure 1.
-
Assemble left, center, and right brackets as shown in Figures 2-4. Tighten H screws first and then G screws.
-
Mount the left Bracket to the wall using two J screws making sure that the large holes face to the right and that the bracket is level.
-
Insert all E shelf tubes into the holes in the left
-
Feed the other end of the E-shelf tubes through the holes in the center bracket.
-
Position the center bracket so that it is as far right as possible while still supporting the E-shelf tubes. Mount the center bracket to the wall using two J screws making sure the bracket is level.
-
Insert the tapered ends of M shelf tubes through the holes in the center bracket and into the ends of the E shelf tubes.
NOTE: The large 3/4″ diameter holes face to the right on the left end shelf support and to the left on the right end shelf support. -
Insert the ends of the M shelf tubes into the holes on the right bracket.
-
Mount the right bracket to the wall using two J crews making sure that the bracket is level.
-
Feed F hanger bar through left and center brackets.
-
Feed N hanger bar through the right and center brackets making sure the tapered end fits into the end of the F hanger bar.
-
Center the hanger bar between brackets and tighten into place with the three I screws.
-
Press one K black end cap into each end of the hanger bar.
1-800-295-5510
uline.com
0621 IH-2515
Documents / Resources
|
ULINE WALL-MOUNT Coat Rack
H-2515
[pdf] User Guide
WALL-MOUNT Coat Rack, H-2515
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>