ULINE LEATHER Executive Chair H-4116 User Guide
- June 7, 2024
- ULINE
Table of Contents
H-4116
LEATHER EXECUTIVE CHAIR
1-800-253-5510
uline.com
TOOL NEEDED
PARTS
ASSEMBLY
-
Insert casters Into the legs of a five-star base. Turn base upright. Insert gas Left Into the center of the base. (See Figure 1)
ASSEMBLY
CONTINUED -
Align mechanism with holes on the bottom of the seat cushion with tension knob facing the front of the seat. Use four 5/16 x 1″ screws (ER to secure. (See Figure 2)
NOTE: Use Men wrench to tighten all screws. -
Align comfiest with holes on the seat cushion and back support. Use four 5/16 x 11/4″ screws (9) to loosely secure. Repeat on the opposite side. Once all eight screws are Installed. fully tighten. Insert plastic caps (10) In holes to cover screws. (See Figure 3)
-
Slowly lower chair assembly onto the gas lift. Press down on the seat cushion to secure. (See figure 4)
CHAIR ADJUSTMENTS
- Seat Height Adjustment – To raise seat height, lift the lever up with little to no weight on the seat. To lower seat height, lift the lever up while sitting.
- Upright Tilt Lock – To lock the chair in an upright position, push the lever toward the center of the seat. To restore tilt, pull the lever out. The chair has a standard tilt; the seat and back tilt simultaneously at the same ratio.
- Tilt Tension – To increase tilt tension, turn the knob clockwise. To decrease tilt tension, turn the knob counterclockwise.
1-800-253-5510
uline.com
0721 IH-4116
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>