ULINE H-5647 Stainless Steel Rotary Drum Pump User Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-5647 Stainless Steel Rotary
_ **Drum Pump User Guide**_
TOOLS NEEDED
SPECIFICATIONS
OPERATING INSTRUCTIONS
IMPORTANT! This pump is made out of 304 stainless steel and PTFE. Use liquids compatible with pump component materials. Follow OSHA guidelines when using this pump, including proper grounding and protective gear as required. For a full list of materials and compatible chemicals, see uline.com. Unit not UL or FM approved.
- Rotate handle clockwise several times to prime. If unit does not prime after a few turns, pouring some fluid into pump inlet may help free pump.
- For siphoning, position handle straight down.
- To stop siphoning, rotate handle 1/4 turn (leave handle in horizontal position).
- After using pump, position handle straight down. Liquid will drain back into the container.
- If pump is removed from drum, rinse it thoroughly in a liquid that is compatible with both the pump and the fluid being pumped.
- Regularly check pump and suction tubes for leaks. Leaks in the suction line or in pump housing will cause inefficient pumping and loss of prime.
Assembly and installation
-
Check to see if all parts are included.
-
Screw discharge spout (1) into casing (3) using PTFE sealant tape provided.
CAUTION! Do not use pipe sealant. -
In order to avoid leakage, use PTFE sealant tape (included) to seal tail pipe (19) with two suction tubes (20).
-
Attach bung adapter (14) onto the top of the assembled suction tube. Screw assembled suction tube into casing (3).
-
Insert handle shaft (17) through handle (13). Thread hex nut (18) onto handle shaft until handle rotates freely.
-
Screw assembled handle to crank arm (12). Keep handle shaft from turning. Tighten hex nut (18) against crank arm. Then, insert crank arm assembly onto rotor shaft and tighten in the rotor shaft.
-
Insert assembled pump into drum through bung adapter (14) and hand-tighten the thumb screw (15). Be sure to set pump and assembled suction tube so that the suction tube is at the desired depth in the drum and is not blocked.