ULINE H-7825 Lectern Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-7825 Lectern
TOOLS NEEDED
Phillips Screwdriver
|
Drill (Optional)
---|---
Two Person Assembly Recommended
PARTS
Camlock Pin x 20
|
Camlock x 20
|
Camlock Cap x 16
|
Deep Camlock Cap x 5
---|---|---|---
L-Bracket x 4
|
Dowel x 18
|
M4 x 16
Machine Screw x 18
|
M4 x 28
Bolt x 3
M4 x 16
Wood Screw x 26
|
Caster x 2
|
Caster with Lock x 2
ASSEMBLY
-
Align paper stop over holes on top reading surface and secure using three M4 x 28 bolts (H). ( See Figure 1 )
-
Place one side panel on ground. Insert camlock pins (A) and dowels (C) into side panel. ( See Figure 2 )
-
Insert camlocks (B) into the holes on the bottom of top reading surface, middle shelf and bottom panel. Insert camlocks into the holes on the back of the front panel. ( See Figure 2 )
-
Place top reading surface, middle shelf and bottom panel onto side panel. Camlock pins (A) will be inserted into holes while camlocks and dowels (C) will be inserted into the empty holes. Repeat for front panel. Tighten camlocks (B) using a Phillips head screwdriver. ( See Figure 3 )
NOTE: _Camlock caps can be applied once camlocks are tightened for a finished look.
_ -
Insert camlock pins (A) and dowels (C) into the remaining side panel. Place this side panel on top of the assembled portion of lectern. Tighten camlocks (B) using a Phillips head screwdriver. ( See Figure 4 )
-
Attach casters (D) to underside of bottom shelf using four M4 x 16 machine screws (G). ( See Figure 4 )
NOTE: Ensure locking casters are installed toward back of lectern, while casters without lock are installed toward front. -
Attach L-Brackets (I) to underside of bottom shelf using six M4 x 16 wood screws (J). ( See Figure 4 )
Documents / Resources
|
ULINE H-7825
Lectern
[pdf] Installation Guide
H-7825, LECTERN
---|---