ULINE H-6575 ADA HEX Picnic Table Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-6575 ADA HEX Picnic Table Installation Guide
TOOLS NEEDED
7/16″ (11 mm) Socket Bit Power Drill (Or Screw Gun) 5 Gallon Bucket (Optional)
Tape Measure Two Person Assembly (Optional)
PARTS
Half Base x 2 Full Base x 1 Left Seat x 2
Right Seat x 2 Leg Anchor Block x 4 Tabletop x 1
Support Arm x 3 ½” Lag Screw x 6
3½” Lag Screw x 26
3″ Drywall Screw x 9 Washer x 32
ASSEMBLY
NOTE: It is important to keep screws loose throughout assembly. Tighten during step 11.
-
Verify all parts are present before beginning. May contain extra hardware.
-
Loosely attach the 4 leg anchor blocks to the bottom of the 4 seats using the 3½” lag screws, washers, power drill and 7/16″ socket bit (will tighten later in step 11). The bored hole on the leg anchor
block faces the side with three edges. (See Figure 1) -
Place the 3 support arms on a flat level surface in a fan pattern. Using the 3″ drywall screws, loosely attach the support arms together (will tighten later in step 11). Use 2 drywall screws per side. (See Figure 2)
ASSEMBLY CONTINUED
-
Loosely attach the seat to the support arms with 8 of the 3½” lag screws and 8 washers through the pre-drilled holes using the power drill and 7/16″ socket bit (will tighten later in step 11). (See Figure 3)
NOTE: The two slightly shorter seats should be attached to the same support arm.
-
Position the seat assembly approximately 10-15″ off the floor. A five gallon bucket under the center works well. (See Figure 4)
-
Twist center supports of base and half base so they are flush with bottom boards. Insert 3” drywall screw into pre-drilled hole through bottom board. (See Figure 5)
-
Insert the three bases under each set of seats. Center each leg to the counter-bored holes in the seat. The full base goes under the support arm with 2 seats. (See Figure 6)
-
Use the 2½” lag screws to loosely attach bases to the seats (will tighten later in step 11). Use a tape measure to ensure that seats are centered and 2″ from base. Make sure the seats are pressed flat against the base. (See Figure 7)
-
Place the tabletop on top of table to align with the holes of the bases. Make sure the support arms are centered. (See Figure 8)
-
Loosely attach each base to the tabletop and support arms using the 3½” lag screws and washers with the power drill and 7/16″ socket bit (will tighten later in step 11).
-
Make sure the table is squared and tighten all lag and drywall screws.
WARNING! Do not lean on tabletop or seats when assembling.
NOTE : H-6681 Mounting hardware sold separately.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>