ULINE H-2267 Multi-Deck Paper Cutter Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-2267 Multi-Deck Paper Cutter Installation Guide
TOOL NEEDED
- 7/16″ Wrench
PARTS INCLUDED
-
1/4-20 x 1/” Hex Head Grade 5 Bolt x 4
-
1/4″ Flat Washer x 4
-
1/4-20 Keps Hex Nut x 4
-
Dowel x 2 (2-Roll Holder) x 3 (3-Roll Holder) x 4 (4-Roll Holder)
-
Foot x 2
ASSEMBLY
- Fasten the two feet onto the frame of the tower as shown in the illustration below by using four bolts, nuts, washers and lockwashers.
- Rest the dowels in the dowel sockets.
PAPER ROLL MOUNTING INSTRUCTIONS
HOW TO LOAD AND DISPENSE THE ROLL
-
Make sure both ends of the roll are plugged with cores. (See Figure 1)
-
Thread dowel through one end of the roll until it protrudes out of the other side. **(See Figure 2)
**
-
To position roll on the paper cutter, rest the dowel in the dowel sockets with the roll unspooling downward under the straight edge blade. (See Figure 3)
-
Pull paper to the desired length and tear against the straight edge blade. (See **Figure 4)
**
Contact Us
Phone: 1-800-295-5510
Web: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>