ULINE H-6104 Plastic A-Frame Sign Instructions
- June 7, 2024
- ULINE
Table of Contents
ULINE H-6104 Plastic A-Frame Sign Instructions
Model: H-6104
INSTRUCTIONS FOR TREATMENT
- Fit a propane torch with a flame spreader.
- Following the operating cautions of the propane torch, ignite the flame.
- Observe the flame in a darkened room, noting the primary (bright blue) and secondary (faint yellow) portions of the flame.
- Adjust the flame so that the primary flame is contained within the spreader and the secondary flame is 1/” beyond the spreader.
- Treat the polyethylene recess area with the tip of the secondary flame by passing it over the polyethylene in gentle sweeping strokes. Total exposure to the flame should be 2-3 seconds, .5 seconds per stroke. This light exposure should not deform or melt the polyethylene in any way.
- Test the polyethylene for bond readiness by wetting it with water. If the water runs off immediately, the treatment was not effective. If the water sheets on the surface, the surface is ready for bonding. If unsure, compare the water’s action on treated area with the untreated area.
- It is recommended to wipe the sign recess area with isopropyl alcohol within 20 minutes of flame treating to ensure positive adhesion.
- Apply a FULL sheet of adhesive vinyl sheeting within 1 hour after flame treating. If applying cut out letters or shapes to the sign, apply them to the full sheet.
Contact Us
Phone: 1-800-295-5510
Web: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>