ENFORCER SK-91ERSD Extended Range Antenna User Manual
- June 7, 2024
- ENFORCER
Table of Contents
Extended Range Antenna
Manual
SK-91ERSD – 315MHz
**SK-93ERSD – 433.92MHz***
- Extends the range of an RF receiver
- Range up to 1,000ft (300m) in open air with existing remote
- Easily plugs into a connector on the receiver’s PCB – No extra wiring needed
- Includes 9ft cable
*Special order
Specifications:
| Model | SK-91ERSD | SK-93ERSD |
|---|---|---|
| Power supply | +5VDC (±0.1VDC) | |
| Current draw | <10mA | |
| Sensitivity | -105dBm | |
| Frequency | 315MHz | 433.92MHz |
| Bandwidth | ±1.0MHz (-3dB) |
Operating
temperature| -22°-176° F (-300-800 C)
Compatibility:
| SK-91ERSD| SK-93ERSD
---|---|---
1-Channel RX| SK-910RAQ| SK-910RA-4Q
1-Channel RX| SK-91ORBQ| SK-91ORB-40
2-Channel RX| SK-910RB20| SK-910RB2-40
3-Channel RX| SK-910R3Q| SK-910R3-4Q
4-Channel RX| SK-910R4Q| SK-910R4-4Q
Installation:
Please read the manual before the installation.
-
Remove the top cover of the RF receiver case.
-
Plug one end of the 9ft antenna cable into the red 3-pin connector on the receiver’s PCB.
-
Cut the wire loop marked “LP3”.
NOTE: If the extended range antenna is later removed, the LP3 loop must be resoldered. -
Run the 9ft cable through the front of the case and then close the case by snapping the top cover back on.
-
Plug the other end of the 9ft cable into the 3-pin connector on the antenna.
-
Mount the antenna as high as possible for maximum range.
IMPORTANT:
- Do not cut, fold, or crimp, the antenna mast.
- Mount the antenna at least 3ft (1m) from the receiver.
- The SK-91ERSD/SK-93ERSD is not weatherproof. If installed outdoors, please use a silicone sealant to seal the case seams, the wiring connection point, and the two antenna connection points.
Various Receiver Terminal/Jumper Locations
California Proposition 65 Warning: These products may contain chemicals that are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
WARRANTY: This SECO-LARM product is warranted against defects in material
and workmanship while used in normal service for one (1) year from the date of
sale to the original customer.
NOTICE: The SECO-LARM policy is one of continual development and
improvement. For that reason, SECO-LARM reserves the right to change
specifications without notice. SECO-LARM is also not responsible for
misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their
respective owners. Copyright © 2021 SECO-LARM U.S.A., Inc. All rights
reserved.
SECO-LARM® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Phone: 949-261-2999 |
800-662-0800
Website: www.seco-larm.com
Email: sales@seco-larm.com
*SK-93ERSD only
PITSW1
MI_SK-9xERSD_210421_ML.docx
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>