ENFORCER SM-217Q/W Miniature Surface Mount Wide Gap Magnetic Contacts User Manual
- June 7, 2024
- ENFORCER
Table of Contents
ENFORCER SM-217Q/W Miniature Surface Mount Wide Gap Magnetic Contacts User
Manual
- Operating voltage: 12~24 VDC
- Wide gap – 2″ (51mm)
- Surface screw mount
- Integrated mounting holes
- Reed switch is SPST deactivated rhodium on gold under-plating
- Screw terminals
- For closed-loop circuits
- Limited lifetime warranty
Parts List
- 10x Contact Switches
- 10x Magnets
- 1x Manual
Specifications
Loop type
| Closed loop
---|---
Electrical configuration
| N.O. (SPST)
Operation gap
| 2″ (51mm)
Connectors
| Screw terminals
Housing Color
| White
Material
- Case
- Contacts
| High-impact ABS plastic
Deactivated rhodium on gold underplating
Contact rating
| 0.75A@24VDC (max.)
0.75A@24VDC (max.)
10W (max.)
Operating temperature
| -15°~160° F (-25°~70° C)
Switch cycles
| 50 Million (0.1mA@5VDC
Switch dimensions
| 2 1 /2″ x1 /2″x9 /16″ (63x13x14 mm)
Magnet dimensions
| 2 1 /2″ x1 /2″x9 /16″ (63x13x14 mm)
Magnet type
| Alnico 5
Installation Notes
Contact and magnet must be installed on the protected side of the door/window.
- Hinged side of door
Installation
Please read the manual carefully before you begin the installation
- Mount the contact above the door or window on the frame. For doors, ensure that the mounting is farthest from the hinged side of the door.
- Connect two wires to the contact terminals and to the alarm control panel.
- Mount the magnet on the door/window so that it will face the contact. Be sure that the gap between the contact and magnet does not exceed 2″ (51mm).
California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
LIMITED LIFETIME WARRANTY
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year..
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2021 SECO-LARM U.S.A., Inc. All rights reserved.
Customer Support
SECO-LARM® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: 949-261-2999 |
800-662-0800
Email: sales@seco-larm.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>