ROCKVILLE Aluminum Wakeboard Tower Speaker Pods Installation Guide
- June 7, 2024
- RockVille
Table of Contents
MAC Series
ALUMINUM WAKEBOARD TOWER SPEAKER PODS
ASSEMBLY GUIDE
Thank you for purchasing these MAC series Aluminum Speaker Pods. Please read
these instructions carefully before use. Make sure all parts are included. If
any parts are missing please contact our technical helpline at
1-646-758-0144, Monday through Friday,
9 am to 10 pm EST., and Fridays, 9 am to 3 pm EST.
Go to vimeo.com/218663778 or scan the OR code
to watch the video, which covers everything you need to know to set up this
item.
STEP 1
Remove the top half of the clamp. Attach the bottom half of the clamp to the
top of the can using the supplied bolts, washer plate. and ellen wrench. Make
sure that the curved side of the washer plate is facing up.
STEP 2
Thread the speaker wire through the predrilled center hole as shown in the
illustration.
STEP 3
Before beginning, make sure that the speaker wires are connected to the
speaker and Mat they have been threaded through the predrilled hole at the top
of the can. Align the mounting holes on the speaker with the corresponding
holes on the can Use a Phillips head screwdriver to tighten the screws.
Although the predrilled holes will accommodate most speakers on the market.
there may be some that don’t fit. If that is the case, you can drill holes
into the lip of the can to line up with your speaker’s mounting holes.
STEP 4
If your wake tower has predrilled holes for routing speaker cables, Insert the
cables at this time. If the clamp does not fit snugly, use one of the 4
included rubber Inserts. Place the top half of the clamp over the wake tower
pole and attach it to the lower half. Do not overtighten the screws. If you
need an insert other than the ones that are included. email us at:
sales@rockvilleaudio.com.
© 2021 ROCKVILLE 11 The Information presented is subject to change and or improvement without notice
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>