AcuRite 06000RM 3-in-1 Sensor Wind Cup Assembly Instruction Manual
- June 7, 2024
- Acurite
Table of Contents
AcuRite 06000RM 3-in-1 Sensor Wind Cup Assembly
3-in-1 Sensor Wind Cup Assembly
model 06000RM
If you’re experiencing problems with your 3-in-1 sensor such as no wind speed readings or lower than expected wind speed readings and your 3-in-1 sensor is mounted properly, the bearings of the wind cup assembly may be worn and will require replacement.
NOTE: A 3-in-1 sensor is required to install the Replacement Wind Cup Assembly. You will need to remove your 3-in-1 sensor from it’s mounting location to install the new assembly.
WHAT YOU NEED:
- 3-in-1 sensor
- Phillips head screwdriver
REMOVE BATTERIES FROM SENSOR TO ELIMINATE ERRONEOUS READINGS WHEN HANDLING AND TRANSPORTING SENSOR:
- Press the release lever and pull off the lower housing of the sensor.
- Remove the battery compartment cover and remove the batteries.
- After the sensor bearing is replaced, reinsert the batteries.
Follow the polarity (+/–) diagram in the battery compartment.
Replace the battery compartment cover and the lower housing of the sensor.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>