ACURITE 00609SB Wireless Weather Thermometer Instruction Manual

ACURITE 00609SB Wireless Weather Thermometer Instruction Manual

Instruction Manual

Package Contents:
[1l Main Unit [Al with stand [1l
Wireless Sensor [Bl
[1l Instruction Manual
[1l Hardware Bag

A. Main Unit                  B. Wireless Sensor

Thank You for purchasing this ACURITE® product. This wireless thermometer features outdoor temperature and humidity, outdoor temperature memory (daily high/low), and indoor temperature and humidity. Please read this manual in it’s entirety to fully enjoy the benefits and features of this product. Please keep this manual for future reference.

NOTE: A clear film is applied to the LCD at the factory that must be removed prior to using this product. Locate the clear tab and simply peel to remove.

( 1 • OVERVIEW OF FEATURES

(2 • SETUP

Install Batteries
NOTE: Install all batteries in both 0 units within a 6 minute period to
ensure proper wireless functionality.

A. Wireless Sensor

1. Remove the 4 battery ,• compartment screws.
2. Remove the battery / REMOVE 4 SCREWS compartment cover and TO OPEN BATTERY COMPARTMENT 2 “AA” install 2 fresh “AA” batteries as shown here.

Always install batteries into the wireless sensor FIRST

to ensure proper wireless synchronization with the main unit.

Operating Range of Batteries

Extended periods of cold temperatures ( below -4°F / -20°c )
can cause alkaline batteries to function improperly. This will Bfiiii-hM (70GC) 158°F I cause the outdoor wireless sensor to stop transmitting
@Qffl (10DC)158°F I temperature readings. Use lithium batteries in these low temperature conditions to ensure continued operation for wireless sensors placed outdoors

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR
LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Follow the polarity(+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO
_ NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries.
DO NOT_ short-circuit the supply terminals.

Select Celsius (°C] or Fahrenheit (°F]

The main unit is capable of displaying the indoor and outdoor temperature readings in either 0 c or °F.
To select either 0 c or °F, slide the switch located within the battery compartment to the desired measurement unit.

Close Battery Compartment Covers

After you have installed fresh batteries and have selected °C or °F, you may now close the battery compartment covers on both the main unit and the wireless sensor.

Basic Setup is Now Complete

The wireless sensor will soon send a signal to the main unit and the two units· will be synchronized . It may take a few minutes for synchronization to complete. If both or one of units appear to be functioning improperly, refer to the troubleshooting section in this manual.

3 • PLACEMENT

Now that setup is complete, you must choose a location to place the wireless sensor and the main unit. The wireless sensor MUST be placed less than 100 feet from the main unit.
This wireless thermometer uses radio frequency for communication, which is susceptible to interference from other electronic devices and large metallic items or thick walls. Always place both units at least 3 feet away from appliances ( TV, microwave, radios, etc.] or objects ( large metal surfaces, thick stone walls, etc.] that may interfere with the wireless communication.

Placement of Main Unit

Place the main unit in a dry area free of dirt and dust. To help ensure an accurate indoor temperature measurement, be sure to place the main unit out of direct sunlight, and away from any heat sources or vents in your home.
There are 2 placement options for the main unit. You may hang the main unit on a wall using the integrated hang hole on the back. Alternatively, you may use the detachable “table stand” to place the main unit on a table top or other flat surface.

Placement of Sensor

The wireless sensor MUST BE PLACED OUTDOORS to observe outdoor temperatures and relay the outdoor temperature to the main unit display. The wireless sensor must be placed less than 100 feet from the main unit.
The wireless sensor is water resistant and is designed for outdoor use. However, to extend the life of the product, place the wireless sensor in an area protected from direct weather elements. To ensure an accurate outdoor temperature measurement, be sure the wireless sensor is placed out of direct sunlight and away from any heat sources.
Use the integrated hang hole on the back of the wireless sensor to hang the sensor on a wall or other vertical surfaces outdoors.

Main Unit Detachable Stand

Included with the main unit is a detachable stand for table top placement.

Remove

Attach

[ 4 • OPERATION

After the main unit and the wireless sensor are both powered on and wirelessly synchronized, no further input is required . The thermometer should provide accurate temperature and humidity readings if properly set up and placed .

Batteries should last approximately one year under normal conditions. When the batteries need replacement, follow the battery installation procedure outlined in this manual exactly to ensure proper operation.

Troubleshooting

Set Wireless ID

This wireless thermometer uses long range 433mhz radio frequency for communication.
In the event that you have reception problems due to interference, both the main unit and the wireless sensor have a selectable wireless ID. The ID switches are located within the battery
compartments of the main unit and the wireless sensor.
You may choose A, B or C; but both the main units and the wireless sensors IDs must match for successful synchronization.

b oth wireless ID’s must match

5 • PRODUCT SPECIFICATIONS

Measurement Ranges

Temperature

Main Unit: 32°F to 122°F / o°C to 50°C
Wireless Sensor: -40°F to 158°F / -40°[ to 70°[

Humidity

Main Unit: 20% RH to 95% RH
Wireless Sensor: 20% RH to 95% RH
Accuracy:+/ – 5 units RH

Specifications

Power Requirements Main Unit: 3 x ..AA” alkaline or lithium batteries
Wireless Sensor: 2 x “AA” alkaline or lithium batteries Wireless Communication Radio Frequency: 433 mhz Transmission Intervals: every 16 seconds

Please DO NOT return product to the retail store.

For technical assistance and product return information, please call Customer Care: 877-221-1252 Mon. – Fri. 8:00 A.M. to 4:45 P.M. (CST)

LIMITED ONE YEAR WARRANTY

Chaney Instrument Company warrants that all products it manufactures to be of good material and workmanship and to be free of defects if properly installed and operated for a period of one year from date of purchase. REMEDY FOR BREACH OF THIS
WARRANTY IS EXPRESSLY LIMITED TO REPAIR OR REPLACEMENT OF DEFECTIVE ITEMS. Any product which. under normal use and service. is proven to breach the warranty contained herein within ONE YEAR from date of sale will, upon examination by Chaney, and at its sole option, be repaired or replaced by Chaney. In all cases, transportation costs and charges for returned goods shall be paid for by the purchaser. Chaney hereby disclaims all responsibility for such transportation costs and charges.
This warranty will not be breached, and Chaney will give no credit for products it manufactures which shall have received normal wear and tear, been damaged, tampered, abused. improperly installed, damaged in shipping, or repaired or altered by others than authorized representatives of Chaney.

THE ABOVE-DESCRIBED WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES. EXPRESS OR IMPLIED, AND ALL OTHER WARRANTIES ARE HEREBY EXPRESSLY DISCLAIMED. INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTY OF MERCHANTABILITY AND THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. CHANEY EXPRESSLY DISCLAIMS ALL LIBILITY FOR SPECIAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES. WHETHER ARISING IN TORT OR BY CONTRACT FROM ANY BREACH OF THIS WARRANTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. CHANEY FURTHER DISCLAIMS ALL LIABILITY FROM PERSONAL INJURY RELATING TO ITS PRODUCTS TO THE EXTENT PERMITTED BY LAW. BY ACCEPTANCE
OF ANY OF CHANEY’S EQUIPMENT OR PRODUCTS, THE PURCHASER ASSUMES ALL LIABILITY FOR THE CONSEQUENCES ARISING FROM THEIR USE OR MISUSE. NO PERSON. FIRM OR CORPORATION IS AUTHORIZED TO ASSUME FOR CHANEY ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF ITS PRODUCTS. FURTHERMORE, NO PERSON, FIRM OR CORPORATION IS AUTHORIZED TO MODIFY OR WAIVE THE TERMS OF THIS PARAGRAPH. AND THE PRECEDING PARAGRAPH, UNLESS DONE IN WRITING AND SIGNED BY A DULY AUTHORIZED AGENT OF CHANEY. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

For in-warranty repair, please contact: Chaney Customer Care

Customer Care Department 877-221-1252
Chaney Instrument Company Mon-Fri 8:00 a.m. to ‘4:’45 p.m. CST
965 Wells Street
Lake Geneva, WI 53147

Read More About This Manual & Download PDF:

References

• AcuRite Weather Monitoring | #1 Weather Station Brand in North America

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>