THUNDERX3 TC3BW Gaming Chair User Manual
- June 7, 2024
- THUNDERX3
Table of Contents
THUNDERX3 TC3BW Gaming Chair User Manual
Chair Parts
Please check and ensure the following parts are in the package. If any parts are missing or not included, please call the local distributor for assistance. Local distributor information can be obtained from ‘Where to Buy’ on thunderx3.com
Group-1
Caution: Use protective gloves for this step. Work Gloves Required! Using bare hands may cause serious injury.
Assemble the Seat
Parts of Group-1
Hold the metal bracket down firmly before pulling the lever. When the lever is
pulled, it causes the metal bracket to spring into an upright position almost
immediately.
Caution
-
Attach the backrest to the seat.
-
Fasten with screws provided.
-
Fasten the protective covers with provided screws.
-
Align the butterfly mechanism with the screw holes at the bottom of the seat as shown in image below.
NOTE : Place the screws by hand before tightening them in an X Pattern with the alien key.
Assemble the Wheel Base
Parts of Group-2
-
Push and twist the wheels into the star base.
-
Place the cylinder cover over the gas lift.
-
Place the chair face down and insert the star base into the butterfly mechanism.
Attach Headrest Cushion
-
Put headrest cushion on the backrest.
-
Pull the straps through the shoulder belt hole and click them into place.
Attach Back Cushion
Pull the straps through the Waist belt holes and click them into place.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>