TELTONIKA TRB145 4G-LTE Gateway User Guide
- June 7, 2024
- teltonika
Table of Contents
TRB145
Quick Start Guide v2.5
| FRONT VIEW | FRONT VIEW |
|---|
| 
DB9 CONNECTOR PINOUT|
---|---
****| 1. Driver negative signal (D-).
2. Receiver negative signal (R-).
3. Ground (GND).
4. Driver positive (D+).
5. Receiver positive signal (R+).
6. Power input 9-30 VDC (Vin).
POWER SOCKET PINOUT
HARDWARE INSTALLATION
1. Unscrew two back panel hex bolts and remove the back panel.
2. Insert your SIM card into the SIM socket.
3. Attach the panel and tighten the hex bolts.
4. Attach the mobile antenna (max torque 0.4 N·m / 3.5 lbf·in) and
connect the USB cable.| 
---|---
DEVICE CONFIGURATION
- Power on the device and connect the USB cable to your computer.
- Allow the gateway to boot up. This might take up to 30 seconds.
- Your computer’s OS should detect the USB device and install the driver.
- To enter the gateway’s Web interface (WebUI), type http://192.168.2.1 into the URL field of your Internet browser.
- Use login information shown in image A when prompted for authentication.
- After logging in pay attention to the Signal Strength indication displayed in the Mobile widget (image B). To
maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.
| 
---|---
TECHNICAL INFORMATION
Radio specifications
RF technologies| 2G, 3G, 4G
Max RF power| 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE
**Bundled accessories specifications***
Power adapter| Input 0.4 Ag100-240 VAC, Output 9 VDC, 0.5 A, 4-pin plug
Mobile antenna| 699-868 / 1850-2690 MHz, 50 a VSWR<3, gain** 1 dBi,
omnidirectional, SMA male connector
*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation
when a cable is used. The user is responsible for compliance with the legal
regulations.
SAFETY INFORMATION
TRB145 gateway must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.
Hereby, TELTONIKA NETWORKS declares that this TRB145 is in compliance with
the essential requirements and other relevant provisions of
Directive 2014/53/EU.
Instruction Manual: Connect the power adapter to turn on the device. Open
192.168.2.1 in your web browser to configure it. More information on
https://wiki.teltonika-networks.com/
The full text of the EU declaration of conformity is available at the
following
Internet address: https://wiki.teltonika-
networks.com/view/TRB145_CE/RED
wiki knowledge base
https://wiki.teltonika-networks.com/
This sign means that all used electronic and electric equipment should not be
mixed with general household waste.| This sign means that the product meets
the requirements of the applicable EU directives.
---|---
www.teltonika-networks.com
©2021 Teltonika Networks
References
- Amazone service client telephone tel contacter contact Amazon
- Teltonika Networks - LTE Routers, Gateways & Modems for IoT
- wiki.teltonika-networks.com
- wiki.teltonika-networks.com/
- wiki.teltonika-networks.com/view/TRB145_CE/RED
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>