TELTONIKA TRB145 4G LTE RS485 Gateway User Guide

June 7, 2024
teltonika

TELTONIKA Logo Networks
TRB145
Quick Start Guide v2.4

TELTONIKA TRB145 4G LTE RS485 Gateway - SembolWiki knowledge base
https://wiki.teltonika-networks.com/
TELTONIKA TRB145 4G LTE RS485 Gateway - QR
https://wiki.teltonika-networks.com/

FRONT VIEW
TELTONIKA TRB145 4G LTE RS485 Gateway - FRONT VIEW

|

BACK VIEW
TELTONIKA TRB145 4G LTE RS485 Gateway - BACK VIEW

---|---

DB9 CONNECTOR PINOUT
TELTONIKA TRB145 4G LTE RS485 Gateway - DB9 CONNECTOR
PINOUT

|

  1. Driver negative signal (D-).
  2. Receiver negative signal (R-).
  3. Ground (GND).
  4. Driver positive (D+).
  5. Receiver positive signal (R+).
  6. Power input 9-30 VDC (Vin).

---|---

POWER SOCKET PINOUT

TELTONIKA TRB145 4G LTE RS485 Gateway - POWER SOCKET
PINOUT

HARDWARE INSTALLATION

  1. Unscrew two back panel hex bolts.
  2. Remove the back panel.
  3. Insert your SIM card into the SIM socket.
  4. Attach the panel and tighten the hex bolts.
  5. Attach the mobile antenna (max torque 0.4 N•m / 3.5 IV. in) and connect the USB cable.

| TELTONIKA TRB145 4G LTE RS485 Gateway - Driver negative
signal
---|---

DEVICE CONFIGURATION

  1. Power on the device and connect the USB cable to your computer.
  2. Allow the gateway to boot up. This might take up to 30 seconds.
  3. Your computer’s OS should detect the USB device and install the driver
  4. To enter the gateway’s Web interface (WebUI), type http://192.168.2.1 into the URL field of your Internet browser.
  5. Use login information shown in image A when prompted for authentication.
  6. After logging in pay attention to the Signal Strength indication displayed in the Mobile widget (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.

B

MOBILE -65 dBm
Data connection Connected
State

Registered (homed OPERATOR; 4G (LTE)

SIM card slot In use|

Ready

Bytes received/sent|

 348.7 KB / 223.5 KB

TECHNICAL INFORMATION

Radio specifications


RF technologies| 2G, 3G, 4G
Max RF power| 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE

**Bundled accessories specifications***

Power adapter| Input: 0.4A@100-240VAC, Output: 9VDC, 0.5A, 4-pin plug
Mobile antenna| 698-960/1710-2690 MHz, 50 0, VSWR<2, gain** 2 dBi, omnidirectional, SMA male connector

*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for compliance with the legal regulations.

SAFETY INFORMATION

TRB145 gateway must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.
Hereby, TELTONIKA declares that this TRB145 is in compliance with the essential requirements and other relevant provisions of Directive RED.
The full text of the EU declaration of conformity is available at the following internet address: https://wiki.teltonika- networks.com/view/TRB145_CE/RED
Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.2.1 in your web browser to configure it. More information on
https://wiki.teltonika-networks.com/

For more information visit www.teltonika-networks.com
This sign means that all used electronic and electric equipment should not be mixed with general household waste.
This sign means that the product meets the requirements of the applicable EU directives.
www.teltonika-networks.com
©2020 Teltonika

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals