TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router User Guide

: June 7, 2024
: teltonika

Table of Contents

**POWER SOCKET PINOUT
HARDWARE INSTALLATION
LOGIN TO DEVICE
TECHNICAL INFORMATION
**SAFETY INFORMATION
Documents / Resources

Networks
Quick Start Guide v2.3
Wiki knowledge base
https://wiki.teltonika-networks.com/

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Route-
QRr https://wiki .teltonika-networks.com/

FRONT VIEW

|

BACK VIEW

---|---

**POWER SOCKET PINOUT

**

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-
power

HARDWARE INSTALLATION

Pull out the SIM needle from the front panel of the router.
Push the SIM holder button with the SIM needle.
Pull out the SIM holder.
Insert your SIM card into the SIM holder.
Slide the SIM holder back into the router.
Attach all antennas.
Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
Connect to the device via an Ethernet cable connected to the LAN port.

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-
HARDWARE

To enter the router’s Web interface (WebUI), type http://192.168.1.1 into the URL ﬁeld of your Internet browser.
Use login information shown in image A when prompted for authentication (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.

B.

MOBILE|

-65 dBm

---|---
Data connection|

Connected

State|

Registered (homed OPERATOR; 4G (LTE)

SIM card slot In use|

Ready

Bytes received/sent|

348.7 KB / 223.5 KB

TECHNICAL INFORMATION

Radio specifications

RF technologies| 3G, 4G, GNSS
Max RF power| 24 dBm@WCDMA, 23 dBm@LTE

**Bundled accessories specifications***

Power adapter| Input: 0.4A@100-240VAC, Output: 9VDC, 0.5A, 4-pin plug
Mobile antenna| 698-960/1710-2690 MHz, 50 0, VSWR<2, gain 2 dBi, omnidirectional, SMA male connector
GNSS antenna| 1575.42~1602 MHz, 2.2~5 VDC, VSWR<1.5, active total gain 28 dB (typ.), RHCP polarization, SMA male connector
---|---

*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for compliance with the legal regulations.

**SAFETY INFORMATION

**

Hereby, TELTONIKA declares that this RUTX09 is in compliance with the essential requirements and other relevant provisions of Directive CE/RED.
The full text of the EU declaration of conformity is available at the following
internet address: https://wiki.teltonika-networks.com/view/RUTX09_CE/RED
Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.1.1 in your web browser to conﬁgure it. More information on
https://wiki.teltonika-networks.com/

For more information visit www.teltonika-networks.com
This sign means that all used electronic and electric equipment should not be mixed with general household waste.
This sign means that the product meets the requirements of the applicable EU directives.
www.teltonika-networks.com
©2020 Teltonika