PHILIPS 1220FR-GL Relay Controller Instruction Manual
- June 10, 2024
- Philips
Table of Contents
DDRC1220FR-GL
Relay Controller
Installation Instructions
Devices must be installed in an approved enclosure by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
You must leave a one channel gap between channels if they are on different
phases. To use channel 1, it must be on the same phase as the supply
terminals. You must leave a one channel gap between channels if they are on
different phases. To use channel 1, it must be on the same phase as the supply
terminals.
Output Ratings/Channel (CH)
| Load Type | CH1-CH12 |
|---|---|
| General Use | 16 A, 277 V (UL) |
20 A, 240 V (CE)
Incandescent
Standard Driver
Electronic Driver| 16 A, 277 V
Motor| 16 FLA (1 HP), 120 V 14.5 FLA (2 / 2 HP), 240 V 14.1 FLA (3 HP), 277 V
Inrush Current| 500 A
Output Ratings/Group
DDRC1220FR-GL ≤ 180 A
CH-CH ≤ 300 V (UL) / 400 V (CE) Federal Communications Commission (FCC)
Compliance Notice: Radio Frequency Notice – This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: Reorient
or relocate the receiving antenna. Increase the separation between the
equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help. Any modifications not approved by
the manufacturer of this device could void the user’s authority to operate
this device.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la Classe B est conforme a la
norme NMB-003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded.
© 2024 Signify Holding. All rights reserved. Specifications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and the Philips Shield
Emblem are registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
www.dynalite.com
AZZ 380 0224 R28
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>