Z-CAM Z CAM EVF – Electronic Viewfinder User Guide
- June 6, 2024
- Z CAM
Table of Contents
Z CAM EVF Electronic Viewfinder
What is in the box?
- Z CAM EVF Electronic Viewfinder
- Plastic eyepiece
- LEMO to D-Tap power cable
- 2x WiFi antenna
How to install the EVF?
- Fix EVF onto the camera rig through the rosette.
- Take off the lens cap of the diopter.
How to power the EVF?
- Connect the LEMO plug of the power cable to the LEMO power socket on the rear of EVF.
- Connect the D-Tap plug of the power cable to a V Mount battery (12V~16.8V).
- How to feed video sources to EVF?
- HDMI signal – connect to HDMI socket on the rear of EVF.
- SDI signal – connect to SDI socket on the rear of EVF.
How to install a WiFi antenna?
- Open the flap of the antenna port on top of EVF.
- Screw-in the antenna clockwise.
- Install both antennas.
- Antennas are needed only for wireless transmission.
How to turn on EVF?
- Make sure that power is connected.
- Slide the power switch to the upward position.
- To turn off, slide the power switch to the downward position.
For further detailed instructions please visit www.z-cam.com.
Electronic Viewfinder Introduction
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>