SOUNDPEATS Sonic Earbuds In-Ear Bluetooth Headphones User Manual
- June 6, 2024
- SoundPEATS
Table of Contents
SOUNDPEATS Sonic Bluetooth Earbuds
USER MANUAL
Pairing
- The earbuds automatically pair to each other after being taken out from the charging case. The indicator of the main earbud flashes in orange and white alternately, and the indicator of the second earbud stays on white.
- Activate Bluetooth on the device, and hit “SOUNDPEATS Sonic” on the Bluetooth list to pair.
Reset
- Clear the pairing record on your devices.
- Place back both earbuds into the charging case and make sure they are in charging status.
- Press and hold both MFBs for 10s until both LEDs on the earbuds flash white twice, reset completely.
Wearing
Product Diagram
Button Control
Function
|
Operation
---|---
Power On| Auto: Take out the earbuds from the charging case
Manually: Press and hold the MFB for 1.5s
Power Off| Auto: Place back into charging case
Manually: Press and hold the MFB for 8s
Play / Pause| Single tap the MFB
Volume –| Double-tap the left MFB
Volume +| Double-tap the right MFB
Previous Track| Press and hold left MFB for 1.5s
Next Track| Press and hold right MFB for 1.5s
Answer / Hang Up Phone Call| Single tap the right MFB
Reject Phone Call| Press and hold the MFB for 1.5s
Switch Between Two Calls| Press and hold the MFB for 2s
Manually Enter Pairing Mode| Press and hold the MFB for 5s
Activate Voice Assistant| Triple tap MFB on the right earbud
Game Mode| Triple tap MFB on the left earbud
Turn on/off the indicator| Tap MFB for 4 times
Game Mode
SOUNDPEATS Sonic uses the latest technology and is equipped with game mode. In
the game mode, ，earbuds delay will be greatly reduced to ensure the
synchronization of
the game audio and picture.
Triple tap MFB on the left earbud to turn on/off the game mode. The earbud
prompts “Game Mode” when the mode is on, and prompts “Exit Game Mode” when
it’s off.
Q & A
Q1: What do the charging LEDs tell while charging the case?
The LEDs stay on while charging, and turn off after fully charged.
When taking out/placing back the earbuds,
the indicator of the headset will light up for
10s to show the current battery status of the charging case:
100%—50% Shows Green
49%-10% Shows Yellow
Below 10% Shows Red
When charging the charging case, the indicator will flash slowly:
Below 20% The indicator flashes in red slowly
20%-69% The indicator flashes in yellow slowly
70%-99% The indicator flashes in green slowly
100% The indicator stays on green
Q2: Why are the earbuds
still connected to my phone after placing them back?
1. The charging case is out of battery. The case will not turn off the
earbuds if the case
battery is dead.
2. Please make sure the earbuds sit well in the charging case, and the
charging
contactors on both the earbuds and charging case are clean. If not, please try
something like a microfiber cloth to clean the contactors.
Q3: The battery life is not as advertised?
A single charge will not give you 45 hours of playtime constantly. The earbuds
work around 15 hours per charge with average use. The charging case provides
another 2
recharges.
FCC Statement
This equipment hos been tested and found to comply with the limits for a Class B digital device, pursuant to Port 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful Interference in a residential installation. This equipment generates uses and con radiate radio frequency energy and. if not installed and used In accordance with the instructions. may cause harmful interference to radio communications.
However there is no guarantee that Interference will not occur in a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to Corrects the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into on outlet on a circuit different from thot to which the receiver is connected
- Consult the dealer or on experienced radio/TV technician for help.
This device complies with port 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including Interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>