Klipsch T2 True Wireless Earphone Owner’s Manual
- June 6, 2024
- Klipsch
Table of Contents
Klipsch T2 True Wireless Earphone
©2020, Klipsch Group, Inc. is a wholly-owned subsidiary of Voxx International Corporation. Klipsch and Keepers of the Sound are trademarks of Klipsch Group Inc., registered in the U.S. and other countries. Product of China.
POWER
PAIRING
CONTROLS
STATUS INDICATORS
CHARGING
FACTORY RESET
IMPORTANT SAFETY INFORMATION
-
READ these instructions.
-
KEEP these instructions.
-
HEED all warnings.
-
FOLLOW all these instructions.
-
DO NOT use this apparatus near water or moisture.
-
If you hear ringing or experience pain or discomfort in your ears during or after using any in-ear audio product, that is a sign you are listening too loud.
When your ears are exposed to high volumes (in excess of 85dB) for over an hour, you may be permanently damaging your hearing. -
TURN DOWN your listening device’s volume to zero before you insert the Klipsch headphones and turn on the device. Once you have the headphones on, gradually increase the volume to a comfortable, moderate volume.
-
DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
-
ONLY USE attachments/accessories specified by the manufacturer.
-
REFER all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
-
NEVER operate a motor vehicle while listening to or wearing your headphones. Not only dangerous, it is illegal in many places.
-
NEVER operate heavy machinery while listening to or wearing your headphones.
-
We don’t recommend you use the headphones while riding a bicycle, running,or walking in heavy traffic areas.
WARNING:
Except in case of emergency, Klipsch recommends you do not use these
headphones or headsets (headphones plus microphone) as aviation communication
equipment as they are not engineered for many environmental conditions common
in commercial or non-commercial aircraft (including, but not limited to:
altitude, temperature, noise conditions, unpressurized aircraft, etc.)
resulting in possible interference to critical communications.
The Occupational Safety Health Administration (OSHA) has issued headphone
usage recommendations for maximum daily exposure and sound pressure levels
(measured in decibels (dB)). A decibel is a unit of measure of sound, and
decibels increase exponentially as sound gets louder. For example,
conversational speech is typically around 60dB, and a rock concert in a
stadium is often about 110dB.
COMPLIANCE INFORMATION
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European Union Low Voltage Directive
2006/95/EC; European Union EMC Directive 2014/53/EU; European Union RoHS
Directive 2011/65/EU; European Union WEEE Directive 2002/96/EC; European Union
Registration, Evaluation, Authorization and Restriction of Chemicals (REACH)
Directive 1907/2006.
WEEE NOTICE
Note: This mark applies only to countries within the European Union (EU) and
Norway.
This appliance is labeled in accordance with European Directive 2012/19/EU
concerning waste electrical and electronic equipment (WEEE). This label
indicates that this product should not be disposed of with household waste. It
should be deposited at an appropriate facility to enable recovery and
recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver.
OSHA GUIDELINES FOR NOISE EXPOSURE LIMITS
Sound Pressure Level
| Recommended Maximum Exposure Per Day
---|---
90dB| 8 Hours
92dB| 6 Hours
95dB| 4 Hours
97dB| 3 Hours
100dB| 2 Hours
102dB| 1.5 Hours
105dB| 1 Hours
110dB| 30 Minutes
115dB| 15 Minutes or less
120dB| Avoid as damage may occur
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Approved under the verification provision of FCC Part 15 as a Class B Digital
Device.
Caution: Changes or modifications not expressly approved by the manufacturer
could void the user’s authority to operate this device.
Caution: To comply with the limits of the Class B digital device, pursuant to
Part 15 of the FCC rules, this device is to comply with Class B limits. all
peripherals must be shielded and grounded. Operation with non-certified
peripherals or non-shielded cables my result in interference to radio or
reception.
This Class B digital apparatus complies with Canadian ICES-003.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
This device complies with ISEDC licence-exempt RSS standard (s)Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference,including
interference that may cause undesired operation of the device.
PRODUCT REGISTRATION
Register your product online at www.klipsch.com/register
- Klipsch will keep you up-to-date on new products and promotions.
- Your personal information will never be resold.
- This registration information is not used for warranty purposes. Please retain your receipt for warranty claims.
WARRANTY INFORMATION
WARRANTY – U.S.
Klipsch Group, Inc, (KGI) warrants to the original retail purchaser that this
product is to be free from defective materials and workmanship for a period of
two (2) year from the date of purchase, if it is properly used and maintained.
This warranty period is not extended if we repair or replace the product. If
this product proves defective in either material or workmanship, KGI, at its
option, will (a) repair the product, or (b) replace the product, at no charge
for parts or labor. If the product model is no longer available and cannot be
repaired effectively or replaced with an identical model, KGI at its sole
option may replace the unit with a current model of equal or greater value. In
some cases, modification to the mounting surface may be required where a new
model is substituted. KGI assumes no responsibility or liability for such
modification. To obtain a repair or replacement under the terms of this
warranty, please return to dealer first, if possible, and the dealer will
direct you accordingly for repairs or replacement. You will be required to
submit a copy of the original receipt.
Return shipping for exchanges/repairs is the sole responsibility of the original retail purchaser.
Limitations:
- This limited warranty does not cover failure of the product resulting from improper installation, misuse, abuse, accident, neglect, mishandling, or wear from ordinary use or environmental deterioration.
- This limited warranty does not cover cosmetic damage, including paint damage, or consequential damage to other components or premises which may result for any reason from the failure of the product.
- This limited warranty is null and void for products not used in accordance with KGI’s instructions.
- This limited warranty is null and void for products with altered or missing serial numbers and for products not purchased from an authorized dealer.
- This limited warranty terminates if you sell or otherwise transfer this product to another party.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER
RIGHTS WHICH VARY FROM STATE TO STATE, JURISDICTION TO JURISDICTION OR COUNTRY
TO COUNTRY. KGI’S
RESPONSIBILITY FOR MALFUNCTIONS AND DEFECTS IN HARDWARE IS LIMITED TO
REPLACEMENT OR REPAIR AS SET FORTH IN THIS WARRANTY STATEMENT. ALL EXPRESS AND
IMPLIED WARRANTIES FOR THE PRODUCT, INCLUDING BUT NOT LIMITED TO ANY IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN TIME TO THE TERM OF THIS WARRANTY. SOME STATES, JURISDICTIONS OR
COUNTRIES DO NOT ALLOW THE EXCLUSION OF CERTAIN IMPLIED WARRANTIES OR
CONDITIONS, OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY OR CONDITION LASTS,
SO THIS LIMITATION MAY NOT APPLY TO YOU. KGI DOES NOT ACCEPT LIABILITY FOR
SPECIAL, INDIRECT, CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING WITHOUT
LIMITATION, ANY LIABILITY FOR THIRD PARTY CLAIMS AGAINST YOU FOR DAMAGES OR
FOR PRODUCTS NOT BEING AVAILABLE FOR USE. THE MAXIMUM LIABILITY FOR WHICH KGI
MAY BE RESPONSIBLE WILL BE NO MORE THAN THE AMOUNT YOU PAID FOR THE PRODUCT
THAT IS THE SUBJECT OF THE CLAIM. SOME STATES, JURISDICTIONS OR COUNTRIES DO
NOT ALLOW THE EXCLUSION OR LIMITATION OF SPECIAL, INDIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO
YOU.
WARRANTY OUTSIDE THE U.S.
The Warranty on this product shall comply with applicable law when sold to a
consumer outside of the United States. To obtain any applicable warranty
service, please contact the dealer from which you purchased this product, or
the distributor that supplied this product.
SPECIFICATIONS
Bluetooth 5.0
A2DP Codecs: SBC, AAC
Range: up to 10m (33 ft.)
Charging Case Input Rating: 5V DC, 0.5A
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>