Klipsch Flexus Surr 100 Wireless Surround Speakers User Manual
- June 1, 2024
- Klipsch
Table of Contents
Klipsch Flexus Surr 100 Wireless Surround Speakers
Specifications
- Product Name: Flexus Surround 100
- Product Type: Surround Speakers
- Compatibility: Flexus Sound System
- Wireless Connectivity: Yes
- Supported Add-ons: Up to 2 wireless subwoofers and 2 wireless surround speakers
Product Usage Instructions:
System Setup
- Insert the Flexus Core into the Transport.
Surround Placement
Place the Surround speakers according to the following diagram:
Surround Level Adjustment
Adjust the surround levels using the remote control to achieve the desired
audio balance.
Surround Reconnect
- Hold the Surround button for more than 1 second to reconnect the surround speakers.
- Hold the Flexus Core button for more than 1 second to reconnect the core system.
Additional Peripherals
- Connect any additional peripherals to enhance your audio experience.
Sound Bar Controls
- On/Off: Power the system on or off.
- Volume Up/Down: Adjust the volume levels.
- Source Select: Toggle between different audio sources.
LED Display
The LED display provides information on pairing status and power
consumption. Refer to the user manual for detailed information.
Important Safety Instructions:
Follow all safety instructions provided in the user manual to ensure safe
usage of the product.
FAQ
Q: How do I pair additional subwoofers and surround speakers?
A: To pair additional speakers, follow the instructions provided in the
user manual or visit klipsch.com/flexus-get-started for more information.
KLIPSCH CONNECT PLUS APP
Scan the QR code for enhanced functionality.
ADD TO YOUR SYSTEM
Flexus Sound System is built to grow with you. Add up to two wireless
subwoofers and two wireless surround speakers to create a home theater.
For more information, please visit: klipsch.com/flexus-get-
started
INSIDE
SYSTEM SETUP
SURROUND PLACEMENT
SURROUND LEVEL ADJUSTMENT
SURROUND RECONNECT
ADDITIONAL PERIPHERALS
SOUNDBAR CONTROLS
LED DISPLAY
| DISPLAY | BAR STATUS | |
|---|---|---|
| **OTHER** | PAIRING | Peripheral pairing |
| PAIR FAILED | Subwoofer/surrounds failed to pair | |
| SURR PAIRED | Surrounds paired |
POWER CONSUMPTION
INFORMATION OF POWER CONSUMPTION
STANDBY MODE| Power consumption is lower than 0.5W at this mode.
**WIRELESS MODE**| In this mode, when there is no signal output, the
idle power consumption is lower than 0.5W after 15 minutes.
IMPORTANT SAFETY INSTRUCTIONS!
- READ these instructions.
- KEEP these instructions.
- HEED all warnings.
- FOLLOW all instructions.
- DO NOT use this apparatus near water.
- CLEAN ONLY with dry cloth.
- DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wider blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- ONLY USE attachments/accessories specified by the manufacturer.
- USE ONLY with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
- UNPLUG this apparatus during lightning storms or when unused for long periods of time.
- REFER all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- DO NOT expose this apparatus to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the apparatus.
- To completely disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle.
- The mains plug/appliance coupler is used as disconnect device, the disconnect device shall remain readily operable.
- DO NOT overload wall outlets or extension cords beyond their rated capacity as this can cause electric shock or fire.
- The equipment shall be used at maximum 113˚F / 45˚C ambient temperature.
The exclamation point, within an equilateral triangle, is intended to alert
the user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.
The lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electrical shock to persons.
WARNING: To reduce the risk of fire or electrical shock, do not expose
this apparatus to rain or moisture.
WARNING: To prevent injury, this apparatus must be securely attached to
the floor/wall in accordance with the installation instruction.
WARNING: No naked flame sources – such as candles – should be placed on
the product.
WARNING: This equipment is a Class II or double insulated electrical
appliance. It has been designed in such a way that it does not require a
safety connection to electrical earth.
WARNING: Do not place batteries in mouth or ingest. Chemical burn hazard.
Keep new and used batteries out of reach of children and pets. If swallowed,
it can cause severe internal burns in just 2 hours and can lead to death.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
WARNING: If battery compartment does not close securely, stop using the
product and keep it away from children and pets.
WARNING: Do not handle leaking or damaged Lithium batteries.
WARNING: Risk of leakage. Only use the specified type of batteries. Never
mix new and used batteries. Observe correct polarity. Remove batteries from
products that are not in use for extended periods of time. Store batteries in
a dry place.
WARNING: Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
WARNING: Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.
WARNING: Do not recharge non-rechargeable batteries.
WARNING: Avoid exposure to extreme heat or cold.
Please dispose of any used batteries properly, following any local regulations. Do not incinerate.
WARNING: Do Not Open! Risk of Electrical Shock. Voltages in this
equipment are hazardous to life. No user-serviceable parts inside. Refer all
servicing to qualified service personnel.
Place the equipment near a main power supply outlet and make sure that you can
easily access the power breaker switch.
WARNING: This product is intended to be operated ONLY from the AC
Voltages listed on the back panel or included power supply of the product.
Operation from other voltages other than those indicated may cause
irreversible damage to the product and void the products warranty. The use of
AC Plug Adapters is cautioned because it can allow the product to be plugged
into voltages in which the product was not designed to operate. If the product
is equipped with a detachable power cord, use only the type provided with your
product or by your local distributor and/or retailer. If you are unsure of the
correct operational voltage, please contact your local distributor and/or
retailer.
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European Union Low Voltage Directive
2014/35/EU; European Union EMC Directive 2014/30/EU; European Union
Restriction of Hazardous Substances Recast (RoHS2) Directive 2011/65/EU;
European Union WEEE Directive 2012/19/EU; European Union Eco-Design Directive
2009/125/EC; European Union Registration, Evaluation, Authorization and
Restriction of Chemicals (REACH) Directive 2006/121/EC; European Union Radio
Equipment Directive (RED) 2014/53/EU.
This product contains batteries that are covered under the 2006/66/EC European
Directive, which cannot be disposed of with normal household waste. Please
follow local regulations.
You may obtain a free copy of the Declaration of Conformity by contacting your
dealer, distributor, or Klipsch Group, Inc.’s worldwide headquarters. Contact
information can be found here:
http://www.klipsch.com/Contact-Us
WEEE NOTICE
Note: This mark applies only to countries within the European Union (EU)
and Norway.
This appliance is labeled in accordance with European Directive 2012/19/EU concerning waste of electrical and electronic equipment (WEEE). This label indicates that this product should not be disposed of with household waste. It should be deposited at an appropriate facility to enable recovery and recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part 15 as a Class B Digital
Device.
Caution : Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate this device.
Caution : To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC
Rules, this device is to comply with Class B limits. All peripherals must be
shielded and grounded. Operation with non-certified peripherals or non-
shielded cables my result in interference to radio or reception.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Industry Canada statement:
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
3502 WOODVIEW TRACE, INDIANAPOLIS, IN, USA
KLIPSCH.COM
©2024, Klipsch Group, Inc. Klipsch Group, Inc. is a wholly-owned subsidiary of
Voxx International Corporation.
Klipsch and Keepers of the Sound are trademarks of Klipsch Group, Inc.,
registered in the United States and other countries. The Bluetooth® word mark
is a registered trademark owned by Bluetooth SIG, Inc. and any use of such
mark by Klipsch Group, Inc. is under license.
V01 – 240122
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>